Curt Class III, IV and V Pin and Clip Review Video

To install replacement latches #TX1117755 you will need to remove the tailgate header rail from the side rails. Then you would remove the one fastener per latch holding the old ones on. Next slide off the old latches, slide the new ones into place,…

Thanks for the picture of the rear latch you have! From that I can tell that the #TX1117755 that you referenced is the correct kit.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

According to SportRack, the capacity of their Frame Adapter Bar #SR0500 is 35 lbs. I've checked with our other bike rack manufacturers such as Thule, Yakima, Kuat and Swagman among others, and have found that the 35 lb capacity is typical. Over…

Yes, the Tekonsha T-One Vehicle Wiring Harness #118605 referenced in your question is confirmed to fit your 2015 Jeep Cherokee Latitude without the towing package. This custom harness will install by connecting directly to the built-in ports located…

I would be happy to help you but the etrailer Hitch item #e73ZR fits the 2019 and newer Jeep Cherokee's so it's not going to be much help determining which has better ground clearance. The hitch with the most ground clearance, that fits your…

We have a few hitches that fit your 2015 Jeep Cherokee. I recommend sticking with a Class III trailer hitch because you'll get all the capacity available from your Jeep and also the 2 inch opening is more common so more accessories are available…

On some years that Curt trailer hitch #13322 fits, there may be some trimming of the rear fascia for the hitch to fit properly. It is not necessary on all models but you will only know once you go to install the hitch. The area that would need to be…

The Rhino Rack RVP roof rack that fits your 2019 Kia Sorento part #RR98TB does not require you to cut the crossbars down to the proper size prior to install. The bars are already the correct size.

The Atwood 31013 is no longer made. The best choice for replacement is the RVCO #RS34FR which mounts flush against the wall, and the overall measurements are 4-1/4" square, and it sticks out 1/2" from the wall. Works with 2-wire…

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…