Trailer Hitch Installation - 2017 Honda -CR-V Video

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You should have enough clearance under a CR-V, however you may not know for certain until you are actually under the vehicle. If you find you do not have enough clearance, you can always jack up the rear end and use jack stands -- as long as you…

Auto makers like Honda get to decide what the towing capacity is for any vehicle they make. This towing capacity is a function of the entire vehicle; its frame, engine, transmission, suspension, cooling system, etc. The online owner's manual…

I checked with my contact at Bulldog and they said that the capacity of the Bulldog Winch Hitch Mounted Winch Mounting Plate #BDW20011, is based on capacity of vehicle receiver. This mount is made for winches up to 12.5 k and does not fit…

There are both Class I and Class III trailer hitches available that are confirmed to fit your 2010 Honda CR-V. The available Class I hitches, such as the Draw-Tite Sport Frame #24792, feature a square tube design, while the Class III hitches like the…

The distance between the hitch pin hole and the bumper of etrailer hitch #e98855 is approximately 3 inches. This is a Class III hitch with a 2" receiver that is a complete bolt-on installation so no drilling into your 2018 Honda Odyssey's…

If you are installing a Draw Tite hitch part #75742 on your 2015 Honda CR-V the Thule T2 Pro XTT part #TH83JV would fit and work well. To answer your first question you would easily have the ability to carry two road bikes with this setup. You also…

For your 2019 Honda CR-V the Tekonsha T-One Vehicle Wiring Harness #118741 will work perfectly. This is a custom "plug-and-play" harness that features a high amp capacity for the lights and comes with Tekonsha's great reputation for…

Unfortunately, we don't have a video installing the Draw-Tite Max-Frame #76128 on a 2017 Honda CR-V as of yet. It would clearly show this process. Generally, lowering the exhaust just means you need to disconnect the mounts that hold the exhaust…

The Draw-Tite Max-Frame Trailer Hitch Receiver #76034 for 2011 to 2017 Ford Explorer models is a great choice. The attached installation video simply uses WD-40 spray as lubricant to remove the exhaust hangers, but we normally use UltraLube Biobased…

We have found out that when you install the Draw Tite hitch part #76128 on a 2018 Honda CR-V like yours you will need to remove the bumper and move the backup sensor 7 inches to the right to allow it to work after the hitch is installed since it…

Honda offers a Power Liftgate Sensor Relocation Bracket as part #08U59-TLA-100A for your 2019 Honda CR-V for when you install a hitch like the Draw Tite part #76128 so that the hands free lift gate will still function properly. That said, we've…