Trailer Hitch Installation - 2016 Honda CR-V - Curt C13119 Video

Using a lift is certainly the most convenient way to go, but is not absolutely necessary. When I installed the hitch on my van, I did not need to raise the vehicle at all. Having the vehicle on jack stands or ramps would make your installation…

I have attached an image from the operation manual for the Demco Hydraulic Brake Actuator #DM8669112 that details how to bleed the brakes. The process consists of first elevating the trailer tongue about 4 to 6 inches and then loosening or removing…

I spoke with my contact at Tekonsha, who is doubtful the controller is the issue. The voltage from the controlleer that's sent to the actuator is very minimal, it's just telling the actuator when and how hard to fire. The actuator is actually…

To trim the underbody panel on your 2013 Honda CR-V for the installation of a Curt Trailer Hitch Receiver #C13119, I recommend marking the area that needs to be cut to start with. I have provided a graphic showing where this section is and the…

You are correct that both the Curt #C94WR and Draw-Tite #DT22MR you were looking at for your 2022 Hyundai Tuscon are very similar. Both hitches share the same 525lb tongue weight and 3,500lb trailer weight ratings, both share the same hidden…

I have attached a video for you to help you bleed the surge brakes and also given an explanation below. You want to top off the master cylinder and pump the fluid from the master cylinder. You can do this by unbolting the plate that holds the lever…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I did some checking and it looks like your 2016 Honda CR-V has a 1,500 lb towing capacity so as long as you stay under that trailer weight you'd be fine to install a hitch like the #75742 that you referenced. I attached an install video for this…

I have a solution for you to use your Kuat Transfer 2 bike rack with a 1-1/4" shank in a 2" receiver, but the #D101 will not fit on the Transfer 2 or any other first generation Kuat rack. Instead, I recommend using the Hitch Reducer 2"…

To answer the most basic part of this question first, you are correct that only Class I hitches with 1-1/4" receivers are available for your 2007 Honda Accord, but if your weight estimates are correct, they will be sufficient to handle this job.…

The problem you are experiencing is pretty common for vehicles that have seen a couple winters. What happens is the weld nuts get a bit of corrosion in them and that prevents the bolts from being able to thread. This makes it seem like the nuts are…

The best trailer hitch for your 2018 Honda CR-V Touring with the hands-free tailgate is the Curt, part #C13397. I prefer the Curt over the Draw-Tite hitch, part #76128, because the Curt's crossbeam is completely hidden behind the vehicle's…