T-One Vehicle Wiring Harness Installation - 2017 Honda CR-V Video

The trim area is skewed to the drivers side. In the 2020 model year video, at the 4:15 mark you can see that it is skewed to the drivers side, or to say left of the tow hook. What our own installers do is to put one bolt in each side (closest to the…

We have not had a chance to install the Draw-Tite Trailer Hitch Receiver #76128 on a 2021 Honda CR-V yet, but we have installed it on a similar 2020 Honda CR-V. The measurement from the ground to the lowest point on the receiver was right at 11"…

The install of the Tekonsha kit part #118741 that you referenced does require the a separate ground wire get attached to the vehicle but the Curt harness part #C56370 for your 2019 Honda CR-V does not require this extra wire. It ground through the…

In regards to the Curt Trailer Hitch Receiver part #c13397 which is a fit for a 2023 Honda CR-V, the trim diagram shows a cutout 3" wide x 1.375" tall, placed .625" to the right of the center rear fascia support tab. It sounds like…

I attached an install video for the T-One trailer wiring harness part #118741 that you referenced on a 2017 Honda CR-V just like yours for you to check out. At the 2:30 mark of the video you'll see our installer digging pretty deep into the…

For the Curt Trailer Hitch Receiver #C13397, we will have a video when we have the ability to get a 2017 Honda CRV into our installation bay. If you look at the installation details I've attached, you will see the look on the vehicle as well as…

For your 2019 Honda CR-V the Tekonsha T-One Vehicle Wiring Harness #118741 will work perfectly. This is a custom "plug-and-play" harness that features a high amp capacity for the lights and comes with Tekonsha's great reputation for…

The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector item #118741 hangs over the back bumper through the rear cargo area when it is in use. The door closing on the wires will not damage it. When its not in use you just roll it up and…

Before purchasing you are going to want to determine if the vehicle has the factory tow package or not. The definitive way to determine this is to contact a Kia dealer and have them run the VIN and they will be able to tell you how the vehicle is…

The first noticeable difference between the Draw-Tite #76128 and Curt #C13397 trailer hitch receivers for your 2019 Honda CR-V is the design and what it looks like after it is installed. The Draw-Tite looks like a standard trailer hitch where the…

For Curt trailer hitch #C13397 it is recommended to remove the lower fascia if your 2017 Honda CR-V has the hands-free liftgate option so that it and the sensor bracket can be trimmed. Regardless though removing the fascia or at least loosening it…

There is a Class III trailer hitch with a 2 inch receiver that will not require you to cut the bumper fascia on your 2018 Honda CR-V, the Draw-Tite #76128. The reason why is because the Draw-Tite models has a visible crosstube, as you can see by the…