etrailer.com Trailer Hitch Installation - 2016 Honda Odyssey Video

According to my research, the Toyota Highlander doesn't have the connector under the dash to install a brake controller. In order to install your brake controller, you'll need to hardwire the controller using our Brake Controller Installation…

To install the etrailer Trailer Hitch #e98862 on your 2016 Honda Odyssey you will put the brackets of the hitch over the flanges you're talking about. Once you torque down the hardware the hitch will be secured to the frame of your vehicle and…

The Draw-Tite Trailer Hitch Receiver, #76025, that fits the 2013 Honda Odyssey will give you more clearance than the Draw-Tite #75270 hitch. The #76025 hitch sits higher up under the bumper which will give you more ground clearance. In our…

I attached a link to the install video for the Draw Tite hitch part #76025 as well as a link to the install instructions for you to check out as well.

Thanks for all of the dimensions you listed. Since drop/rise needs the measurement from the ball mount platform and not the top of the ball you will need to take one more measurement to be sure. That measurement compared to the 14-1/2 inches is the…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

If you removed the hitch ball of the Curt Class III Ball Mount #C45034 and reinstalled it with the ball mount in the rise position this would be possible to be used in the rise position.

We don't have a combo of the Curt Hitch Ball #C40008 and Curt Ball Mount #C45340. The ball mount is extremely heavy-duty, rated up to 17,000 pounds. I think it's safe to assume you don't have a torque wrench rated up to 450 foot pounds…

There are a couple of things to check with the installation of Curt trailer wiring harness #C56378 on your 2016 Honda Odyssey. First, make sure the fuse is installed in the red power wire. If it is installed make sure that the fuse is good and…

In order to install the Draw-Tite Max-Frame Trailer Hitch Receiver part #76025 on a 2014 Honda Odyssey you"ll need to trim the fascia in the center to allow the receiver tube opening to pass through and above the tail pipe. The reason you must…

Yes, the Swagman XP #S64940 that you referenced does come with an anti-rattle hitch pin. If you check out the review video I attached you will see it getting used.

For all of the specifications that you are looking for, I believe that a single arm rack with rotating cradles would be the best option, like the Swagman XP, #S64940. This rack is ultra-sturdy, has a good finish that can be kept up with a bit of…