Trailer Hitch Installation - 2016 Audi Q5 - Draw-Tite Video

That's a good question but no, the bumper on your 2015 Audi Q5 will not be damaged more easily and will not be more fragile with the installation of the Draw-Tite Max-Frame Trailer Hitch Receiver #75940. The bumper support is directly…

Hey Norm, the Curt hitch part #C13136 is the correct fit for your 2009 Audi Q5 and would work great when towing your boat trailer. Since your vehicle doesn't have the factory tow package you would need to go a different route for trailer…

The stealthiest hitch we offer that fits your 2015 Audi Q5 is the Draw Tite part #75940 which only has the hitch opening hanging below the rear fascia. See attached picture to see what it looks like installed. We do not have any options that are…

The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…

If you currently have a working 4-Way plug then using the 7-Way RV Upgrade Kit for Trailer Brake Controller Installation Kit part #ETBC7 kit is a great way to get a powered 7 Way connector on the rear of your 2014 Audi Q5. You can use the Curt…

If you wanted to move the fifth circuit of your 5-way from being a reverse light circuit to a brake light circuit you certainly could. You would just need to remove it from the reverse light circuit and then wire it up to the front of the vehicle and…

For your 2014 Audi Q5 there are 2 hitches which are a confirmed fit. We have the Draw Tite hitch part #75940 which is a fit and the Curt #C13136 which is also a fit and the one I recommend since it has an easier install and better price. The years…

The best trailer hitch for a bike rack on your 2016 Audi Q5 is easily the Draw-Tite Max-Frame Trailer Hitch #75940 because it offers the best bumper clearance and ground clearance of the hitches that fit your vehicle. This is a 2" hitch with a…

Yes, the Draw Tite Hitch part #75940 that you referenced is a confirmed fit for your 2011 Audi Q5. This hitch does replace a support beam of your rear bumper but does not require any cutting or drilling aside from that. I attached a picture from the…

The Curt Pin and Clip #F-4 that you referenced is designed to work on 1-1/4 inch hitches. The reason your hitch has a 1/2 inch hole and a 5/8 inch hole is because it is setup for an obsolete anti-rattle device Draw Tite J-Pin. We no longer carry the…

I included an image from the instructions for the Draw-Tite #75940 that will show what needs to be trimmed on your 2013 Audi Q5. This is specific for models without Fascia hitch access panel, so it should get you all squared away. I also included an…

Like you said, there are no restrictions for Draw-Tite trailer hitch #75940 on a 2016 Audi Q5 models with back up camera and parking sensors. It is listed by Draw-Tite as a fit for all models of the 2016 Q5. The only note on it is that on models that…