Trailer Hitch Installation - 2011 Honda CR-V - Curt Video

The connection point is located behind the interior trim panel in the cargo area on the driver side. The 4-pole trailer connector will be stowed inside the cargo area of the vehicle. You will need to open the rear door of the vehicle and temporarily…

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…

I don't think that your wheel size (or lack thereof) has anything to do with the bearings on your HF trailer drying out as much as it is likely that the seal blew out from overfilling the grease or poor installation. This isn't uncommon when…

I couldn't tell you what, if anything, Harbor Freight has in the way of replacement parts for your trailer. But a wheel is a wheel and a tire is a tire. As long as both are the right size you can use any that fit. We have a lot of tire and wheel…

I do have a solution for you, but we do not recommend using vehicle tires on a trailer. Trailer tires are built with stronger sidewalls to help resist the load that is put on them, while vehicle tires are made for a more smooth ride. Also, we do not…

There are several things to consider when switching to larger tires and wheels on a trailer. First you need to consider the height difference. On a 4.80x8 trailer tire, you are looking at a diameter of about 16 inches. On a 13 inch, like #AM3S040,…

I attached a picture that shows the install instructions for the Curt hitch part #C11555 that you referenced for you to check out.

This mounts inside the garage overlapping the doorway. You will need to measure the inside of your RV's garage width from wall to wall for which is best fit. The LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen, #3441409775PBK is…

The Draw-Tite trailer hitch receiver, part #75547, uses 4 hex bolts that are M10 X 1.25 X 30. However, you shouldn't tap the threads uness you absolutely have to as a last resort. I highly recommend cleaning them before tapping them. I've…

If you check out the installation instructions linked to this page for the Draw-Tite Max-Frame Trailer Hitch Receiver #75699 that you referenced you will see the correct torque specs for the M14 bolts that already exists on your 2011 Jeep Grand…

For your 2016 Honda CR-V, I'd recommend the #Draw-Tite Class III hitch, part #75742. For a trailer wiring harness, if needed, use the Tow Ready #118561. Unfortunately, the 2011 model was the last year of the 3rd generation of the CR-V models, and…

The EcoHitch Hidden Trailer Hitch Receiver part #306-X7291 which is a fit for a 2008 Honda CR-V does indeed require trimming of the rear bumper fascia but no drilling. I have attached a photo of the required trimming for you which as you can see is…