Trailer Brake Controller Installation - 2006 Dodge Ram Pickup 39510 Video

The Optronics LED RV Interior Light with Switch - 18 Diode - Surface Mount - White Housing #RVILL34 and the Patrick Distribution 18-LED Surface Mount Dome Style Light Fixture - 12V #277-000114. There is not a lumen rating on the slimmer light from…

Correct, there will need to be a small amount of wiggle room or play between the trailer coupler and hitch ball which is to allow the trailer to track and turn smoothly. If the connection point between the trailer coupler and hitch ball was too…

You can add a 7-Way trailer connector and retain the use of a 4-Way as well by installing #37185. The 4-Way you have will plug into the 37185 and the remaining wires would have to be hardwired in. The white wire grounds to the truck frame. Black is…

To install your Prodigy P3 #90195 brake controller on your 2006 Dodge Durango without a tow package you will need to first add a 4-way, the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118390. I have added a link to an…

If your 2005 Dodge Ram 1500 came with a factory 4-Way or 7-Way trailer connector at the rear then yes, there is an OEM harness under the driver's side dash and to the right of the emergency brake pedal. Typically this should be blue but the color…

The auxiliary 12-volt wire that runs from the 7-way connection to 7-way trailer plug will supply 12-volt power from the vehicle to the trailer. The 12 -volt power will allow interior or exterior lights to run that are not wired in to the…

The brake controller port you have found in your 2005 Dodge Ram doesn't go all the way back to the rear of your vehicle, it stops at the connector that is located under the driver's side wheel well. In order to finalize the installation you…

If the 4-Way did not come on the truck from the factory, then there probably will not be a brake controller connector under the dash. Even if it is a factory 4-Way, not all of the 2005-2007 Ram trucks that were equipped with a 4-Way from the factory…

Brake controllers such as the P3 you referenced #90195 will go into a sleep mode after about 15 minutes of it sensing no movement. If you peek through the window after 15 minutes then it should be in sleep mode. Opening the door or causing movement…

Manufacturers change the wire colors on vehicles for seemingly no reason sometimes. Actually, the colors get changed because there is some engineering change that causes them to make wire color changes. Your truck must be one of the models that has…

The Prodigy P3 trailer brake controller uses a 4-wire hookup. The white wire is to be grounded to the battery negative terminal; the black power wire connects to the battery hot terminal through a circuit breaker; the red wire takes in the brake…

If you already have a breakaway switch and trying to find its power source, It is possible that someone could have wired the breakaway switch directly to the main battery on the trailer but it does not come like that from the factory. The breakaway…