Hayes Engage Trailer Brake Controller Installation - 2014 Jeep Grand Cherokee Video

I spoke a representative from Yakima about the Lift Brackets for Yakima ReelDeal or Big PowderHound and PowderHound Carriers - Qty 2, part #Y8860037. They said these brackets will give you almost 4" of additional clearance. The lift brackets do…

While it is feasible, it is not the recommended way to add lift. Instead, what you can do is replace your hangers with longer ones, or go with a Timbren axle-less system. You will get 4" of lift by using #ASR3500S06, which has a capacity of…

To install the Redarc Tow-Pro Liberty Trailer Brake Controller #RED24FR you were looking at all you will need is the Plug-In Adapter #RED39FR. This will plug into the controller of the #RED24FR and then plug directly into the factory trailer brake…

For the 2001 Chevy Silverado with or without a factory 7-Way trailer connector, the wiring for the brake controller is present. However on some models there are additional connections that will need to be made under the hood to make everything fully…

The red wire on a brake controller signals the controller that you are stepping on the brake pedal, so it has to be connected. It does not operate the brake lights on the trailer. It attaches to the cold side of the brake switch. The brake switch is…

The trailer brake controller plug on your 2017 Nissan Pathfinder SL will be located underneath and left of the steering column, taped to another harness near the emergency brake pedal. This location is also revealed in the attached install video. If…

When it comes to installing The Redarc Tow-Pro Liberty #RED52VR if there is no trailer connected, the active calibration may occur as normal without any indication from the LED., provided your brake light trigger point is active when there is no…

Yes, when installing the knob for the Redarc Tow-Pro Liberty Brake Controller item #RED24FR you will want to remove any extra material behind the insert. I am happy the video was able to help you out. I have linked a couple of pictures from the video…

Your answer depends on what connector you have. If the Ranger has a factory-installed 7-way it should have a standard brake controller connection port above and to the left of your left knee when seated; this will be near the kick panel. If the truck…

I'd be happy to assist with that. In addition to the #HA81725 Hayes Synchroinizer brake controller, you'll need a universal wiring harness, part #HA81789-HBC and our Brake Controller Installation Kit, part #ETBC7. The kit includes everything…

The red wire on a trailer brake controller like the Redarc Tow-Pro Liberty Brake Controller part #RED24FR when using the Universal Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers part #RED69FR will need to be attached to the cold side of…

The trailer wiring harness for your 2014 Ford Explorer is actually quite easy to install. Take a look at the picture I've attached. There are two connectors at the rear on the passenger's side. The wiring harnesses we carry, like part #118540…