Front Mount Trailer Hitch Installation - 2003 Chevrolet Tahoe - Curt Video

The install of the Curt front hitch part #31302 that fits your 2003 Chevy Silverado 1500 Z71 does not require the permanent removal of the tow hooks.

If you were to install the Curt #31302 Front Mount Hitch so that it is the "through bumper" instead of "under bumper" configuration you will need to cut out a 3 inch square hole that is located 3-1/2 inches below the top edge of…

The Curt Front Mount Trailer Hitch, #31302, can be installed on your 2003 Chevy Silverado 1500 HD in two ways. It can be installed with the hitch receiver through the bumper which would require a 3 inch square hole to be cut into the plastic fascia,…

If your 2002 Silverado is not the HD model then yes it would be the LD version. For your LD version, we have the Curt hitch #31302. This hitch has a 2 inch receiver opening.

When it comes to a front mount trailer hitch receiver for your 2003 Chevrolet Silverado 1500 Light Duty Series 4x4, we only have one option, but it is a good one. The Curt #31302 is a confirmed fit and a solid choice for your Silverado. I have…

Check the driver's side rear seats on your 2004 Chevy Silverado. If there is a hole at the seat bracket through which you can insert the lock then you can use #DU80090. Otherwise you would have to drill but I am fairly certain that you won't…

Look at the door of your truck. Does it say 1500HD? If so you have an HD version of the 1500 Silverado and the correct front hitch you need is #65028. If you don't see the HD at the end of the 1500 you have the LD and the correct hitch is…

The Redline 36 Inch Side-Door Bar Lock Assembly, #305736, can be used on the right and left side. The image on our product page shows it in the left hand orientation, but it can be used on the right hand side by flipping it upside down. Check out the…

Yes, the hasp - or keeper latch - is included with the 36" Lock Side-Door Bar Lock Assembly #305736. The only thing you will need to get separately are is the mounting hardware, which will be 5/16" carriage bolts and matching washers and…

For your 2001 Chevy Suburban the 4WD or the 2WD will not matter for the front hitch. The choice for your vehicle will be if it is the 1500 series or the 2500 series Suburban. If you have the 2001 Chevy Suburban 1500, the Curt Front Hitch, #31302 will…

The Draw Tite hitch part #65052 is a confirmed fit for your 2007 Chevy Tahoe and will bolt right up to the frame without any modification. It does drop down 7-3/4 inches from the frame where it attaches as well like you mentioned.

To achieve a 10 inch drop to keep your tow bar within the "Safe Zone" (3 inches above or below level) I definitely recommend going with a single high-low adapter that features the full 10 inch drop. The potential issue with using 2 adapters…