Draw-Tite Max-Frame Trailer Hitch Installation - 2019 Acura RDX Video

According to the installation instructions for the Draw-Tite Max-Frame Trailer Hitch Receiver part #76268 which is a fit for your 2019 Acura RDX, the exhaust must be lowered temporarily in order to position the hitch up under the vehicle. If you are…

The diameter of the hitch pin hole for the Curt #13241 trailer hitch receiver is 5/8 of an inch. A Pin and Clip, like part #C21500, is designed to fit into the hitch pin hole. You can use part #e98882 for an option that locks.

I have what you need! I went ahead and pulled the Curt Hitch #C95CR from the warehouse to measure for you. From the front of the receiver tube, the center of the pinhole is 1-7/8". From the rear of the receiver tube, the center of the pinhole is…

The Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C95CR will fit on 2021 Acura RDX, but with the factory trim piece it will not be very hidden. This receiver does offer a simple bolt-on installation process and requires no drilling…

The Draw Tite hitch part #76268 fits only the 2019 Acura RDX at this time (August 2019). If you have a different vehicle let me know and I can recommend a hitch for it as well.

If you were to install both the Draw-Tite Max-Frame Trailer Hitch Receiver #DT79MR (76342) and #76128 on your 2022 Honda CR-V you'd find that the DT79MR is going to sit about 1/2" higher so these are relatively at the same height. With that…

The Draw-Tite Class III hitch you specified, part #76268 has two holes in each side of the receiver tube. The larger 5/8 inch diameter hole is meant for the hitch pin. The smaller hole is not used. So, in regards to your question-the larger hole is…

Correct, the Draw-Tite Max-Frame Trailer Hitch Receiver part #76268 which is a fit for your 2019 Acura RDX does indeed sit below the rear spare tire. Generally speaking, hitch manufactures will position the receiver tube so it does not stick out past…

I definitely have those measurements! I pulled the Draw-Tite Hitch #76268 from the warehouse and measured it for you. From the front of the hitch receiver tube, the center of the pinhole is 2-3/8". From the rear of the receiver tube, the center…

We personally don't have any photos as of yet (February 2019) as we haven't had a chance to install the Draw-Tite #76268 on a 2019 Acura RDX but I do have a picture from the installation instructions which I have attached for you to check…

When installing the Draw-Tite Trailer Hitch Receiver #76268 on your 2020 Acura RDX you will remove the rubber isolator from the silver prongs (hanger) with either exhaust removal pliers or a simple pry bar. I have added a link to the instructions for…

The Draw-Tite Max-Frame Trailer Hitch Receiver part #76268 which is a fit for your 2019 Acura RDX with Advance Package will not impede the use of your hands free liftgate sensors. However, you will need to position your foot to either the right hand…