Which Pin Hole in Draw-Tite 76268 Class III Hitch Is Used for Bike Rack Hitch Pin
Question:
Hi is it a problem to use the larger pin hole the one closer to the car for a bike rack? The hole is much larger than the pin, but this is the way it seems to work best.
asked by: Sara G
0
Expert Reply:
The Draw-Tite Class III hitch you specified, part # 76268 has two holes in each side of the receiver tube. The larger 5/8 inch diameter hole is meant for the hitch pin. The smaller hole is not used.
So, in regards to your question-the larger hole is indeed meant to be used for the hitch pin.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Curt vs. etrailer Trailer Hitch Receiver For 2024 Acura RDX
- Q&A: How Does Hitch Tongue Weight Rating Affect Use of a Motorcycle Carrier on a Toyota Sienna
- Q&A: How To See If 2019 Acura RDX Has Plus 12v Power Provision Without Removing Interior Trim Panels
- Q&A: Do You Have Any Images Of The etrailer Trailer Hitch Receiver On a 2019 Acura RDX?
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Pinhole Measurement from Front and Rear of the Curt Hitch # C95CR
- Q&A: Will Trailer Hitch Get in Way of Kick Sensors for 2020 Acura RDX Advanced Model
- Article: Which Hitches are Made in the USA
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Hitch Receiver Sizes
- Article: Best Bike Racks for Electric Bikes
- Article: Trailer Wiring Diagrams