CIPA Clip-on Towing Mirror Installation - 2018 Ford Edge Video

The best hitch for ground clearance on your 2013 Ford Edge Sport is the Draw Tite part #75728 that you referenced because it has a crosstube that sits above the hitch opening which means that only the hitch tube will hang down. While that may not…

The Draw-Tite Trailer Hitch Receiver #75728 is for the Ford Edge Sport and will not fit your 2013 Ford Edge SEL. On you SEL model instead you need Draw-Tite #75992. It is designed to fit models with dual exhaust. I've attached a picture of the…

As long as the side-view mirrors on your 2013 Ford Edge have a gap between the mirror and the mirror housing, the CIPA Clip-On Universal Towing Mirrors, #7070, will fit. This is a universal mirror that was designed to fit many different mirror styles…

The towing capacities for the Draw-Tite Max-E-Loader Trailer Hitch Receiver #75728 are: Maximum gross trailer weight: 3,500 lbs Maximum GTW when used with weight distribution: 4,000 lbs Maximum tongue weight: 525 lbs Maximum TW when used with weight…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…