Best 2014 Ford Mustang Hitch Options Video

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I checked the owner's manual for your 2007 Hyundai Santa Fe and there are a few towing capacities listed, depending on your vehicle's engine size and whether or not it has a factory trailer package. If your Santa Fe does not have the trailer…

The only trailer hitch options for a 2014 Ford Mustang are class I 1-1/4" like the Curt Trailer Hitch Receiver part #C11210 which is what I recommend. It can be adapted to a 2" using the Hitch Adapter 1-1/4" to 2" Trailer Hitch…

All of the hitches that are available for your 2012 Ford Mustang GT will install in basically the same place and they will not stick out too far. I attached a picture of the Curt Hitch #C11210 installed on a vehicle that is similar to yours for you…

For a hitch for your 2013 Ford Mustang you would want the Draw Tite hitch part #24863. To install this hitch on your vehicle you would not need to modify the rear fascia/body of your vehicle. I attached an install video for this hitch for you to…

Let me start by saying you're definitely asking all the right questions to make sure you can safely carry your gear on a cargo carrier and you're definitely right to question what you were told. Most of what you're asking are things that…

If you have a 2013 Ford Mustang GT or Non GT convertible, you can use either the Draw-Tite #24863 or the Curt #C11210. These will both give you the same capacity, but one I recommend more than the other. I recommend getting the Curt as it has a…

The Curt Trailer Hitch Receiver part #C11210 which is a fit for a 2013 Ford Mustang Convertible does not require a stability strap, just the bike rack will be fine. It has a class I rating with 1-1/4" opening so any bike rack with a 1-1/4"…

Where we installed the Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" #C11210 on a similar 2014 Ford Mustang V6 we found that from the ground to the top inside edge of the receiver measured 10-1/2". As long as the tires on your…

I do have some information that will help determine if you will need to modify the fascia on your 2012 Ford Mustang California Special, however, I spoke with my contact at Draw-Tite and he did not have any specific information regarding the fascia…

As long as your Mustang is not a California Special, Shelby GT or a GT500 model, then yes, the Curt Class I Trailer Hitch, #C11210, will fit. No drilling is required to install and the exhaust must be temporarily lowered to raise the hitch into…