Today we are going to show you a cheat. In some cases you are going to have a hitch that uses threaded holes in the bottom of the frame. Those holes are going to be probably corroded up within a few years of the vehicle being on the road with dirt, grime, salt corrosion, you name it is probably in there inside the fine thread. What you want to do is clean out the threads probably with an… see more >
Videos
Help Articles
Expert Answers
We get this question quite a bit and the issue is really that the threads end up with quite a bit of corrosion and dirt which prevents the bolt from threading in. I attached a couple help articles that cover cleaning out weld nuts for you to check…
view full answer...The Kuat NV 2.0 #NV22B measures 55-1/8 inches wide overall, folded or unfolded. The height when folded is 25-3/4 inches. When unfolded it is approximately 13 inches tall. When unfolded the rack is 37-3/8 inches front to back. When folded up it is…
view full answer...The Kuat NV 2.0 Base Bike Rack for 2 Bikes #BA22B comes with the cable locks and hitch pin lock keyed alike so you would only need 1 key for your lock. It sounds like you swapped out the hitch pin, this would cause the cable locks to no longer be…
view full answer...The Draw-Tite Trailer Hitch Receiver part #36297 which is a fit for a 2007 Volvo XC70 (All Models) does not come with hardware. That said, you won't need to obtain any either as it uses existing bolts already on the vehicle.
view full answer...All of the available trailer hitches for a 2004 Volvo XC70 are class II hitches with a gross trailer weight capacity of 3,500 pounds and a tongue weight capacity of 300 pounds. If the combined weight of your horse and trailer (loaded and ready to…
view full answer...The best hitch for your 2023 Honda Passport is going to be the Curt Trailer Hitch Receiver item #C13421. This hitch is custom fit and bolts to your Honda with included hardware. I really like the Curt hitch because it installs right below your rear…
view full answer...The red wire you are seeing is related to the under hood connections to make the factory tow package fully functional. The problem you are describing with the brake switch wire is common. Those wires are very thin on some vehicles. There can be other…
view full answer...This is a very common issue. The issue is that the weld nuts are still dirty and need to be cleaned further or tapped so that your hitch hardware can install. We have the correct thread tap to use with the hitch #C13073 with the part #PTW8618.
view full answer...To answer the last question first you could attach some quick links to the safety chain loops on Curt trailer hitch #C15410 so that they are compatible with smaller hooks. We have different size quick links and S-hooks depending on your needs and I…
view full answer...The bolt sizes that come with the Draw Tite hitch #36408 which fits your 2008 Chevy Equinox is M12 for the vertical brackets that attach to the outside of the frame. It's not uncommon to need to tap out rusty weld nuts on vehicles with a few…
view full answer...To figure out if your 2009 Pontiac Montana SV6 has the short or long wheel base would be to measure from the center of the rear wheel to the center of the front wheel, or you can call your local GM dealer with your VIN and they should be able to look…
view full answer...The Draw-Tite Max-Frame Trailer Hitch Receiver #75278 is a custom fit receiver and is confirmed to fit your 2008 Chevrolet Uplander LS MiniShort with the 113 inch wheelbase. If you let me know what you will be using the trailer hitch for I can make…
view full answer...