Thread Tap to Use with Hitch Install Hardware for Curt Hitch C13073
Question:
are they the same size ? the bolts sent with my draw tite hitch seem bigger n dont fit.. i did clean em out too. thx.
asked by: Danny B
0
Expert Reply:
This is a very common issue. The issue is that the weld nuts are still dirty and need to be cleaned further or tapped so that your hitch hardware can install. We have the correct thread tap to use with the hitch # C13073 with the part # PTW8618.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Size are the Trailer Hitch Receiver Bolts and Weld Nuts on a 2012 Hyundai Santa Fe
- Q&A: Correct Hitch Lock and Cable For Swagman XTC-2 Tilt Bike Rack
- Q&A: Comparing Curt # 13195 and Draw-Tite # 75908 for 2017 Kia Sorento
- Q&A: Combination Keel/Caster Roller Assembly for Tandem Axle Shorelander Boat Trailer
- Q&A: How to Determine if 2016 Kia Sorento Has Factory Tow Prep Package
- Q&A: Solution for Weld Nuts on 2012 Hyundai Santa Fe that Won't Allow Hitch Bolts to Thread In
- Q&A: Thread Pitch of Hitch Mounting Bolts on 2005 Hyundai Santa Fe
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Hitch Receiver Sizes
- Article: Ball Mount Basics: Weight Capacity, Class, and Size