Review of TorkLift Camper Tie-Downs - Front Tie-Downs Aluminium - TL36CR Video

For 4WD models you'll need to use the TorkLift Custom Frame-Mounted Camper Tie-Downs #TLT2303 for the front and #TLT3303 for the rear. If you have a 5' bed and running boards under the cab will need to remove the running boards to install tie…

I spoke with TorkLift about the TorkLift Custom Frame-Mounted Camper Tie-Downs for a 2018 Toyota Tacoma and they stated they have not done any testing on the TRD. That said, it looks like the only issue would be the factory nerf bars so if these are…

The TorkLift Custom Frame-Mounted Camper Tie-Downs - Front #TLT2303 weighs approximately 17lbs and the TorkLift Custom Frame-Mounted Camper Tie-Downs - Rear #TLT3303 weighs approximately 19lbs.

There is no drilling required on your 2017 Toyota Tacoma to install the TorkLift Custom Frame-Mounted Camper Tie-Downs - Front #TLT2303. I have added the installation instructions for you to look at, which include the necessary steps needed for…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

Yes you can absolutely use the HappiJac Qwik-Load Turnbuckles for Camper Tie-Downs #LC182895 with your TorkLift tie downs.

The Optronics 7-Way Connector - Trailer End #A7WCB will handle 8-gauge wires on the positive and negative connectors. If you want the same gauge wire on the vehicle side, I recommend the Hopkins Endurance 7-Way Trailer Connector Socket - Vehicle End…

Hey Chip, so we do have a set of Torklift camper tie downs that fit your 2024 Ford F-350 long bed with side steps and a factory hitch with the part number #TL87CR for the front set and part #TLF3008 for the rear set.

According to TorkLift's fitment guide the TorkLift Talon Custom Frame-Mounted Camper Tie-Downs #TLF2021A you were looking at are compatible with any factory installed running boards, including ones that extend under the bed so these would be a…

I attached a picture that shows the Torklift Camper Tie Down #TLF2021 installed on a truck with a set of running boards. If the running boards are cab length they'd be fine, but if they go from the wheel well to wheel well they would interfere as…

The primary advantage of frame-mounted camper tie-downs like the TorkLift #TLF2012A and #TLF3001A, which are designed to fit your Ford F-350 if it has the 6-3/4 foot bed without a step/board underneath and a factory hitch, is the stability they…