Review of Thule Ladder Rack Base Rail Kit - TH21508 Video

The base rails for the TracRac sliding ladder racks are bed length and vehicle manufacturer specific for the most part with a few part number changes as the trucks change generations. So for your 2013 Ford F-160 with a 5-1/2 foot bed the base rails…

I'm assuming you have the 5-1/2' bed on your 2022 F-150 since that is what you put in our guide. If that is the case, the correct rails are the #TH21508. If you meant the 6-1/2' bed then you need the #TH21501.

The correct Thule TracRac SR sliding truck bed ladder rack for a 2018 Ford F250 long bed is part #TH43003XT-000. I've linked to a product demonstration/install video showing the rack being installed. The TracRac SR ladder rack has generous 1250…

The base rails that are designed to fit the 2018 Fort F-150 (5-1/2 foot bed) - Ford Super Crew Trucks #TH21508 come with the Thule TracRac SR Sliding Truck Bed Ladder Rack - 1,250 lbs #TH43002XT-508. The Base Rails for Thule TracRac SR Sliding Truck…

I went ahead and spoke to Peragon, and they did confirm that the Base Rails for Thule TracRac SR Sliding Truck Bed Ladder Racks #TH21610 will work with their tonneau covers, however the Thule ladder racks that are confirmed to fit your truck do not…

The correct replacement base rails you need for the Thule TracRac SR Sliding Truck Bed Ladder Rack part #TH43002XT-501 on a 2022 Ford F-150 with 6.5' bed is the Base Rails for Thule TracRac SR Sliding Truck Bed Ladder Racks part #TH21501.

Thule owns TracRac so yes the Base Rails part #TH21610 would work with a TracRac ladder rack. This base rail is the rail kit of the part #TH43002XT-610 which fits the following: 2007 - 2021 Toyota Tundra 6-1/2 Foot Bed - with Deck Rail System 2007 -…

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

Hey Carl, thanks for writing in, and that's a good question. Thankfully, the answer is no, you do not need to cut or trim the fascia/face plate on a 2024 Ford Maverick to install the Demco base plate that fits, which is the following part number:…

I can definitely help you find the correct replacement hub and bearings for your Dexter P-12 SLR axle, but since part of the serial number was unreadable you will need to take a few simple steps to identify which bearings your axle uses. The easiest…

The Dexter E-Z Flex Suspension Kit part #K71-653-00 will work just fine on 3,500 axles assuming the measurements match up which in your case they do. I have spoken to Dexter about this before and the weight capacity listed is more or less a guide to…