Lippert Components RV and Camper Steps - Motorhome - LC432696 Review Video

Kenny, those bolts for the B&W Companion 5th Wheel Trailer Hitch #BWRVK3500-5W should be torqued to 40 ft. lbs. Also, the pivot arms would need to be torqued to 80 ft. lbs, the draw down bolt should be tighten to 60 ft.lbs and the arms should…

We don't have an install video but what I can do is describe it. The portion of the #LC301704 with the round holes mounts to the bottom of the frame on your trailer with nuts and bolts or welding. They would need to be spaced at the width of…

We don't have an install picture but what I can do is describe it. The portion of the #LC301704 with the round holes mounts to the bottom of the frame on your trailer with nuts and bolts or welding. They would need to be spaced at the width…

Trailer and other RV makers do not maintain specs on smaller items like the steps they install on their RVs but it is not difficult to find replacements based on size. The linked page displays RV and camper steps that are offered in many types. For…

We carry a wide range of replacement RV and trailer step assemblies and these are offered in several sizes and step counts. Based on my research the 2011 KZ Sportsmen 290 travel trailer comes fitted with a 3-step manual unit, one like #LC432690…

The Lippert Manual Pull Out steps part #LC432690 that you referenced is designed to fit the outriggers you have on your trailer. Most RV steps attach to the mounting brackets on the sides like this so what you have is pretty normal. As long as your…

Do you need the mounting base to be 26 inches wide, or the mounting hole locations 26 wide? If this is just an approximation, we have the Lippert Manual Pull-Out Step for RVs - Triple - 9" Drop/Rise - 24" Wide - Steel - 300 lbs…

For Lippert Manual Pull-Out Step #LC432690 the mounting holes are 26-3/8 inches apart on center, side to side, and 7 inches apart on center front to back. The side plates are 16 inches tall. I have included some pictures with these and other…

The Lippert Manual Pull-Out Step for RVs part #LC432690 which is a triple step option would be best for an entry height of 32". The distance from the top of the mounting bracket to the bottom of the step is 25" therefore you will…

The MORryde X-Factor Crossmember part #MR33WR attaches to the leaf spring hangers which are located in-between and in the front and rear of each axle. I have attached a photo below to clarify. Therefore, you'll need three for full support on…

Step #SMFP-2100 is supposed to mount up to factory holes on the bottom of the frame or it can be welded to the frame. For nuts and bolts use #LC118155-72 if you don't already have some from the old steps. For welding the installation should…

From the limited information that I was able to obtain for the original steps on your 2004 Airstream Safari, I recommend taking a look at the TorkLift Glowstep #TLA8103. This unit measures 25-1/2 inches wide and 13-7/8 inches deep at the mounting…