Curt Ball Mounts - Fixed Ball Mount - C45561 Review Video

To determine the rise/drop you need, you'll need to determine the height difference between your receiver and the trailer coupler. I've linked you to an FAQ article that shows how to do this. I've linked you to the Euro Style ball mounts…

The distance from the center of the pin hole to the end of the shank that slides into the hitch is 1-7/8 inches.

The recommended 2 inch Euro style ball mount for Curt trailer hitch #C11352 on a 2015 Nissan Altima is #C45572. I went out to the warehouse and pulled one to take some measurements. From the center of the pin hole to the part of the shank where it…

The only trailer component that determines the speed rating of the trailer is the tires. All you have to do is simply replace your current tires with one that is rated for highway use, like the Kenda Loadstar #AM3S120 that you referenced, and you are…

The hitch drawbar or ball mount is the part that slides into the hitch receiver that has the trailer ball bolted to it. You'll need the ball mount if you plan on towing, but if you're only using the hitch as a mount for a hitch mounted…

Honda doesn't offer an official roof weight capacity for the 2020 Honda Fit even in their owner's manuals. They do not offer factory roof racks since they do not believe the Fit is designed to carry weight. They do say that the total load…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

The drawbar you mentioned is not intended to be used in the rise position and would only create a 3-1/2 inch rise. We do carry a 5 inch and a 3-1/8 inch rise drawbar (see links below) that will fit the Class II hitch. These drawbars all have a tongue…

The Euro style ball mount like the #C45562 that you referenced is only available for the smaller 1-1/4 inch hitch size so best option would be a standard ball mount with same 3 inches of rise like the part #2753 and then for a 2 inch hitch ball…

To determine the amount of rise or drop in a ball mount that you will need to tow a trailer level there are a couple of measurements needed. First make sure the trailer is on level ground. Use the jack to make the trailer level then measure from the…

For Curt Euro style ball mount #C45562, it measure 3-1/8 inches from the top of the shank to the beginning of the vertical curve that leads up to the ball. To the bottom of the ball is just over another 2 inches so it is about 5-3/8 inches to the…

The part #C45562 you mentioned is the Curt Euro Style ball mount with 5-1/8 inches of rise. I just went out to our warehouse and measured it for verification.