Review of Blue Ox Weight Distribution Hitch - 3,500 lb WD With Sway Control - BXW0356 Video

Upgrading the rear suspension in your 2017 Toyota Sienna sounds like a solid plan considering all the weight you are carrying around inside your van. Since you're using a Sienna as a platform you are going to be limited on options for…

Although a thin walled socket, like part #EQ70-00-4800, is not required to install the hitch ball on the Equal-i-zer Weight Distribution #EQ37041ET, it will make the job easier. Typically the torque specs for installing a hitch ball are pretty high…

The etrailer Tongue Weight Scale for Campers and Utility Trailers - 2,000-lb Capacity, #e99044 is compatible with your Scamp as it fits 1-7/8", 2", or 2-5/16" ball couplers. If your Scamp was ordered with a jack that has a…

That will depend on quite a few variables so I can't give you a hard yes or no answer to that question. Things that factor into that is how long is the a-frame on your trailer, how many bikes does your rack carry, and how long is your ball…

What is the distance between the front of your trailer and the coupler ball of it? What is the overall length of the bike rack you have currently? With those two dimensions you could get a pretty good idea where the bike rack would end up and if…

From the hitch pin to the mast is approximately 9" on the Yakima LongHaul, #Y02476.

Even with just two bikes, the weight capacity of the Yakima LongHaul #Y02476 would remain the same at 37.5 lbs per bike. There is a solution for you to haul your beach bikes on your RV, however. If your beach bikes do not have fat tires, I…

The length of the arms on the Yakima LongHaul 4 Bike Rack #Y02476 are 28 inches measured from the center of the upright mast to the end of the arms.

I think your best option is to use theHitch-It 2 Bike Rack for Straight Tongue Trailers #LC731138. This can fit onto your shank or trailer tongue (fits between 2"-3" in diameter) between your vehicle and travel trailer and provides…

I went out to the warehouse to measure the receiver tube of the Stromberg Carlson Bike Bunk Trailer-Mounted Bike Rack Carrier for A-Frame Trailers #CC-275 and found it was roughly 6-1/4 inches. This rack has a 100 lb capacity, fits A-frame trailers…

Of the two adapters you mentioned only the MaxxTow MT70070 is rated for use with your application of towing a trailer and carrying a bike rack with the top hitch. Downside is that it cuts the capacity of the hitch you use it with by 50 percent. A…

At the rear of a trailer the ride quality is very rough when compared to the ride quality at the rear of a passenger vehicle. Reason being the suspension isn't as sophisticated and there is a longer distance between the rear axle and the rear…