Weight Distribution System Availability with Sway Control

Question

Question:

Are you no longer carrying Equalizer hitches??

asked by: Allen

0

Expert Reply:

We did stop carrying the Equalizer brand weight distribution hitches. We do carry several other weight distributions systems though. The Reese Strait Line systems are great and actually have the only sway control system that works to prevent sway before it starts. See link to see all of the Strait Line systems we carry.

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached an FAQ on determining tongue weight for you to check out as well.

expert reply by: Jameson C

0

Answer 1

It sounds like you have a Reese Strait-Line Weight Distribution System with Sway Control #RP66083. This is the system I recommend using with your 2015 Heartland Prowler. Your trailer's gross vehicle weight and tongue weight are within the…

view full answer...

Answer 2

For pulling your 30 foot trailer with your 2003 Yukon XL Denali I would recommend you use a Strait-Line Weight Distribution System with Sway Control, part #RP66083. This system has a tongue weight limit of 800 lbs and a GVWR of 8,000 lbs. It is…

view full answer...

Answer 3

My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…

view full answer...

Answer 4

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 5

I looked up pictures of the taillights that are on the 3110 Featherlite trailers and for the LED version of them you would want the part #STL36RB and #STL37RB. It looks like the spare tire mounts for your trailer are something you would have to get…

view full answer...

Answer 6

I have added a photo detailing the wiring connections for the Pollack Heavy-Duty, 7-Pole, Round Pin conncetor, #PK11700, see link. This is a SAE J560 compliant connector. The wiring diagram for the vehicle side connector, #PK11720, is pictured also.…

view full answer...

Answer 7

We do offer the Trailer Connector Adapter, #HM47425, which converts a 7-pole round connector to a 7-pole flat connector. This adapter works for tow vehicles with combined taillight wiring, meaning that the turn signals and brake lights run on the…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 10

There is a trailer wiring harness for the 2020 Ford Edge Titanium with Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part #C73FR which will plug in behind the tail lights and give you a 4-pole flat on the Edge to power…

view full answer...