How Does the Replacement Fan Switch for Ventline Ventadome Trailer Roof Vents # BV0199-02 Wire

Question

Question:

The push button switch I am replacing has 2 black wires. One is spliced to a black wire that goes to the fan motor. The other is spliced to a yellow and to the coach through the ceiling. The new rocker switch has 2 black wires too but doesnt have instructions on where they connect.

asked by: Gary R

1

Helpful Expert Reply:

Based on the picture you submitted (which was very helpful), it looks like you are replacing the part # BV0199-02 in your Ventline Ventadome roof vent.

Since all that switch does is interrupt current it doesn't matter which wire gets run to each black wire of the switch. Either one can get run to the yellow wire and the other to the black wire.

expert reply by: Jameson C

1

Answer 1

The ThermaHeat RV Dump Valve Pipe and Elbow Heating Pad #277-000162 pulls 0.3 amps and the ThermaHeat RV Holding Tank or Step Heater Pad #277-000164 pulls 4.8 amps. Assuming that you're having them all run off the same switch and wiring you would…

view full answer...

Answer 2

The Replacement Push-Button Switch for Ventline Trailer Roof Vents #BV0199-03 will have one wire as an input and one as an output. The switch simply mounts through a hole with the threaded nut on the outside where the switch and threaded housing…

view full answer...

Answer 3

Thanks for the picture, it looks like you'll just be needing the Replacement Push-Button Switch for Ventline Trailer Roof Vents #BV0199-03.

view full answer...

Answer 4

The #BV0199-03 switch is installed inline on the 12-V power source feeding the fan. One lead connects to the motor, the other to a 12-V power source. The switch was typically used on Vanair Powered vents like #VP-543SP, although Ventline used them on…

view full answer...

Answer 5

The On/Off Push Button Switch for RV Lighting #DG52452VP doesn't have a specific wiring diagram, it would vary depending on your intended use. Basically the switch will install into the circuit you are needing to interrupt so that the current can…

view full answer...

Answer 6

We have the Replacement Push-Button Switch #BV0199-03 that fits with the hole in the Replacement Screen Frame #BVC0515-05. The Replacement Fan Blade #BVD0217-00 works with the 1-1/2" long Replacement 12V DC Motor #BVD0218-00. You will need to…

view full answer...

Answer 7

The Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - White - Birch Trim #V2092SP-25 can be fixed easily. You will start by removing the trim/garnish from the inside of your trailer. Then you will remove the screw from the…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 11

So I have your hub narrowed down to a few different possibilities but we need to know what your bolt pattern is to know for sure. We have the part #84556UC3 for if your bolt pattern is 5 on 5 inch. We have the part #845476UC3 for if your bolt pattern…

view full answer...

Answer 12

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

How Does the Replacement Fan Switch for Ventline Ventadome Trailer Roof Vents # BV0199-02 Wire

Product Page this Question was Asked From

Continue Researching