Do All Trailers with Electric Brakes have to have a Breakaway System

Question

Question:

Do all electric brake systems require a brake away switch

asked by: Jm

0

Expert Reply:

No, but your local and state laws may require one. You will need to check anywhere you will be towing the trailer to determine if a breakaway system is required by law. They are also just a good idea in general because they will stop a run away trailer should it get disconnected from the tow vehicle.

We have several different breakaway options which I have linked to the right. I have also included a link to our help article on breakaway systems for you.

expert reply by: Michael H

0

Answer 1

When measuring to determine the bolt pattern of a wheel with an odd number of lugs, like a 5 lug wheel, you are basically measuring the diameter of a circle that would run through the center of each lug hole. If you are measuring the wheel the…

view full answer...

Answer 2

The main difference between the #331-TPSI-002 and #331-TPSI-007 is the different vehicle years they fit. Both of these parts will fit a Toyota Tacoma like yours but the #331-TPSI-007 fits a 2005-2011 Tacoma while the #331-TPSI-002 fits a 2015 to…

view full answer...

Answer 3

I can certainly help. You will want to look at DOT/FMCSA regulation 393.43, specifically paragraph (d). This regulation should have everything that you need for what the Navy requires. In general, a breakaway system needs to be sufficient enough to…

view full answer...

Answer 4

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

view full answer...

Answer 5

I spoke with my contact at Curt and he said that the Echo #C51180 should not be permanently installed on the trailer frame. Even though it can withstand the elements it isn't meant to be left out when not in use. To mount the 7-Way on your Subaru…

view full answer...

Answer 6

It sounds like the brake controller might need to be reset or the wiring from the vehicle side to the breakaway system needs to be examined. Try adjusting the power output of the controller. If that does not work, you can test the controller itself…

view full answer...

Answer 7

To answer your first question, there isn't a traditional "adapter" to allow the 7 way on your trailer to plug into a 4 way connector on your vehicle- at least not in the manner that you're thinking of. For that reason you would…

view full answer...

Answer 8

The Autowbrake brake controller part #3430001 that you referenced draws up to 15 amps. It's only going to draw amperage when the controller is activating the trailer brake so it would not be something you'd need to install an on/off switch on…

view full answer...

Answer 9

The shortest tire we carry that is designed to fit a 16 inch rim would be the size 235-80R16 that is 30.9 inches in diameter. For that you would want the part #AM10248. I attached a review video for this tire for you to check out as well.

view full answer...

Answer 10

The wire gauges on The Bargman 7-Pole, RV-Style Connector - Trailer End - 22 foot Long 50-67-008 are below: Black and White - 10 Gauge Blue - 10 Gauge Brown, Red, Green, Yellow - 14 Gauge We recommend The 10-1-1 to combat voltage loss over distance.…

view full answer...

Answer 11

The Dexter Trailer Hub and Drum Assembly #84556UC3-EZ referenced in your answer is a 5 on 5 inch assembly that is designed for most 3,500 pound axles. The drum dimensions are 10 inch diameter x 2-1/4 inches wide. This will slide over the axle spindle…

view full answer...

Answer 12

Each brake magnet should have 2 leads, one to power, one to ground. Most of the time, folks just ground the magnet to the trailer frame, and use the trailer frame itself as the ground circuit. I'd recommend finding the point where the wiring…

view full answer...

Do All Trailers with Electric Brakes have to have a Breakaway System

Featured Help Information

Miscellaneous Media

Continue Researching