Installation Instructions for Draw-Tite # 75699 on 2014 Jeep Grand Cherokee Limited
Question:
Part # 75699 Draw-Tite I did not receive a product guide and I am looking to know how much torque I need to install the bolts as well as the socket size. Would it be metric or US? I am going to buy a torque wrench just for the install. I have a new Jeep Grand Cherokee Limited 2014
asked by: Scott L
0
Expert Reply:
I have attached a link to the installation instruction sheet for the Draw-Tite Receiver Hitch, # 75699. You will need a torque wrench with a 21mm socket to tighten the fasteners. Since torque specs are subject to change, please see the instructions link for the most up to date information.
expert reply by:
Leah S
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: trailer hitch
- Search Results: cargo carrier
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Q&A: Torque Specifications of M14 Bolts Used to Install Draw-Tite # 75699 on 2013 Jeep Grand Cherokee
- Q&A: Size of Factory Bolts For Installation of Curt Trailer Hitch Receiver in Factory Weldnuts
- Video: Choosing the Right Trailer Wiring
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Shop: Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 44649
- Search Results: 68149
- Video: etrailer Hitch Pin Alignment Collar Review
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Brake Controller
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Shop: Fifth Wheel Hitch
- Search Results: dust cap
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Video: Choosing the Right Brake Controller
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: My Trailer Hitch Doesn't Fit
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Search Results: 25580
- Shop: Suspension Enhancement
- Video: Tow Ready 4-Pole Mounting Bracket Installation