Recommendations for Cutting the Garnish for a Ventline Roof Vent
Question:
I must shorten the leg length of two garnishes by about 3/4inch but before I start cutting, I would like to be sure I am using the best technique and tool before I ruin a new garnish. Please give me your expert advice.
asked by: Gary
0
Expert Reply:
I would measure the 3/4 of an inch and mark it with masking taping all around it to use a reference point for where you will make the cut. For the actual cut I would recommend you use a fine tooth saw. Some people use soldering irons to make the cut as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ceiling Garnish for Ventline Roof Vent - 5-1/8" Leg - 14-1/4" x 14-1/4" - Birch White
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Ceiling Garnish
- Ventline
more information >
Continue Researching
- Shop: Replacement Switch Kit for Solera Power RV Awnings - White
- Video: Ventline RV Vents and Fans VA0445-28 Review
- Q&A: Recommended Trim Ceiling Garnish for Ventline Ventadome Trailer Roof Vent
- Article: How to Replace or Install an RV Roof Vent
- Q&A: Replacement Part For Ventline Manual Roof Vents P/N VDO 433 & VDO 434
- Q&A: How Tall Are The Timbren Trailer Suspension Enhancement Springs For Underslung Axles?
- Q&A: Replacement Frame for Ventline Roof Vent VDO434
- Q&A: Replacement Frame and Screen for Ventline VD433 on a 2017 Forest River Salem Ultra Lite 27RBXL
- Q&A: Best Tire Pressure Monitoring System TPMS with Smartphone Display for 8 Trailer Tires
- Q&A: Trailer Tire Replacement Recommendation for P275/75R15
- Article: Trailer Wiring Diagrams
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Motorhome Steps
- Article: RV Roof Types: What Type of Roof Does My RV Have?