What is the Size of the Hole for the UWS Stachion for Toolbox Grab Rails # UWSSTACHONS

Question

Question:

what size pipe does this take?

asked by: Malcom

1

Helpful Expert Reply:

The UWS Stanchion, # UWSSTACHONS, will accept pipes or rails with an outer diameter up to 7/8 of an inch.

expert reply by: John H

1

click to enlarge

Answer 1

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 4

The UWS tool box part #UWS01039 that you referenced is made from 13 gauge aluminum which is .090 of an inch thick.

view full answer...

Answer 5

The Curt Front Hitch #C31076 will install on the front driver and passenger side frame rails. I have linked a picture showing the bolt holes on the passenger side frame rail and it will be the same for the driver's side. I checked and the Curt…

view full answer...

Answer 6

I checked with UWS and the closest non-locking version of the Replacement Lock Handle #UWS003-SLLKBLK available is the Replacement Non-Locking Paddle Handle #UWSNONLOCKING. This polished stainless steel lock works with many UWS toolboxes and its bolt…

view full answer...

Answer 7

The #UWSSTACHONS uses 7/8 inch diameter tubing or pipe which isn't included. The length of pipe would depend on what you decided to use.

view full answer...

Answer 8

The BOLT Toolbox Latch Retro Fit Kit - Codes to Ford Key #BL7022698 is a fit for many truck box manufacturers. I've attached a photo of the overall dimensions for you to compare to your truck box.

view full answer...

Answer 9

You will want the hitch to be set at the height that 1) allows the trailer to be level, and 2) allows you a minimum of 6 inches between the bottom of the trailer loft and the top of the bed rails. The fifth wheel hitches offer several inches of up…

view full answer...

Answer 10

Best way is to drill a hole through the floor of the tool box and then through the bed of the truck and then run a bolt through both. This is the best way to secure a tool box.

view full answer...

Answer 11

The lift cylinders for the UWS toolboxes will lift the lid of a UWS toolbox, but you will need to assist the lift cylinder by lifting the toolbox lid a few inches before the lift cylinder opens the lid the rest of the way. It will not immediately…

view full answer...

Answer 12

Usually, if the lock is going to be able to be replaced it will have a thin nut on the back of the cylinder on the interior of the toolbox that can be loosened and removed. I've included an image to show you what I'm talking about. If you…

view full answer...

What is the Size of the Hole for the UWS Stachion for Toolbox Grab Rails # UWSSTACHONS

Product Page this Question was Asked From

Continue Researching