UWS Stanchion for Toolbox Grab Rails

Video Transcript for Review of UWS UWS DeWalt Stanchion For Toolbox Grab Rails - UWSSTACHONS

Hi, everybody. Andy here with etrailer.com and today we're gonna take a brief look at this UWS Stanchion for Toolbox Grab Rails. This stanchion is going to weld to the top of your UWS or DeWalt aluminum toolbox to mount on grab rails. So this is designed for you specifically on your UWS and/or DeWalt aluminum boxes. And let me get my ruler here and just go over some measurements for you so you can be confident that this is going to work for you. Beginning with the overall height, as you can see, we're sitting right at two inches tall.

And then the overall length, we are sitting right at one and three quarters inches long. The width about seven eights of an inch wide. And the outer diameter here at the widest point, we're sitting right at about an inch and a quarter as you can see. And then that inner diameter, that's probably a little more important to you, we are sitting right at seven eighths of an inch. So this doesn't include any tubing for those grab rails or anything like that.

You're simply going to get one stanchion and if you need more, you can add those to your order. But that should conclude our look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.

.