Will the UWS Toolbox Lift Cylinder Lift the Lid When the Handle is Pulled

Question

Question:

do these replacement cylinders actually lift the lid when latch handle is pulled ?

asked by: Alvin O

1

Helpful Expert Reply:

The lift cylinders for the UWS toolboxes will lift the lid of a UWS toolbox, but you will need to assist the lift cylinder by lifting the toolbox lid a few inches before the lift cylinder opens the lid the rest of the way. It will not immediately begin to lift the lid once you pull the handle.

expert reply by: John H

1

Answer 1

Best way is to drill a hole through the floor of the tool box and then through the bed of the truck and then run a bolt through both. This is the best way to secure a tool box.

view full answer...

Answer 2

I spoke with my contact at UWS and they said that the UWS Replacement Lift Cylinder, part #UWSLIFTCYLIND, will fit all of the UWS toolboxes. The name on the lifts could change if they switch to a different supplier.

view full answer...

Answer 3

The #UWSSTACHONS uses 7/8 inch diameter tubing or pipe which isn't included. The length of pipe would depend on what you decided to use.

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

When it comes to installing The Timbren Rear Suspension Enhancement System #TFRRGR on your 2020 Ford Ranger they come in a pair. The Timbren springs has a 6,000 pound weight capacity, and no drilling is required during the installation. I attached an…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

I reached out to Mad Ramps about the MAD-MOUNT Wall Mount Brackets for Mad-Ramps Pivoting ATV/UTV Ramps part #MR27DR and they informed me that the brackets are both 36" long x 2-1/2" tall. I have attached a photo below with this as well.

view full answer...

Answer 8

Mad-Ramps states that the part #MR54FR is best suited for ATVs/UTVs with one row of seats but if the width of your golf cart is less than 60 inches and the wheel base is less than 88 inches this would work for you.

view full answer...

Answer 9

The newer Ford trucks feature what's dubiously referred to as a 'smart' trailer connector. The connector won't send any power back on the 12-volt accessory circuit (which powers the Echo) until the vehicle is turned on, the…

view full answer...

Answer 10

Sounds like you've done a great job at installing the Redarc Tow-Pro Elite #RED44FR, and that you're on the right track when it comes to installing the Hopkins Endurance Multi-Tow Plug #HM47180 on your 2019 Ford Ranger! To wrap up your…

view full answer...

Answer 11

The only trailer brake controller options we offer for a 2019 Ford Ranger are wireless since there is no trailer brake controller plug under the dash. I recommend the Curt Echo Wireless Brake Controller part #C51180 which you will control and setup…

view full answer...

Answer 12

Hey John, so the correct amount of spring bar tension will be based on the trailer's tongue weight and how it affects the suspension of your Nissan Frontier. Every WD system is a little different but what it comes down to typically is measuring…

view full answer...

Will the UWS Toolbox Lift Cylinder Lift the Lid When the Handle is Pulled

Product Page this Question was Asked From

Continue Researching