Conversion Kit Availability For 1-3/4 Inch Axle On Coleman Pop Up Camper

Question

Question:

I have an coleman pop up camper I want to do a axle flip but will the dexter conversion work? My axle is 1 3/4. Do you sell weld on spring seat that will work to??

asked by: Preston P

0

Expert Reply:

We have two conversion kits we offer and they will work on either a 2-3/8 inch or 3 inch round axle only. They would not work on an axle that measures 1-3/4 inches.

The spring seat we offer for a 1-3/4 inch axle is part # TRSS175. This is designed to be used with a typical 2,000 lb round axle.

expert reply by: Jeffrey L

0

Answer 1

To determine the axle size you will need there are some measurements needed. First, if you are replacing the axle then you can measure the one you have. Measure from the center of one spring seat to the center of the other spring seat. Then measure…

view full answer...

Answer 2

The best way to lift your Jayco Eagle is called an over/under conversion kit, which moves your trailer's leaf springs to the top of your axle and lifts your trailer approximately the same amount as your axle's diameter plus the height of the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 7

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Conversion Kit Availability For 1-3/4 Inch Axle On Coleman Pop Up Camper

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching