Replacement Reverse Lockout Solenoid for Titan Model 10 Brake Actuating Trailer Coupler
Question:
I need the solenoid that goes with the Tital Surge-O-Matic Model 10 surge brake/trailer coupler. On the solenoid it says: Pressure: 800psi Watts: 8W Volts: 12VDC Orifice: 1/32 I could supply a picture if you wish. If you dont have it I sure would appreciate any advice about where I might find it. Thanks
asked by: Russ W
Expert Reply:
I believe you meant Titan Model 10, is that correct?
If so, the Titan # T4748800 Replacement Solenoid Valve you've looked at would be compatible with your coupler. The solenoid would mount between the master cylinder outlet at the rear of your actuating coupler between the outlet and the brake line. The solenoid has two wire leads. One wire would ground to the trailer, the other would connect to the center pin of the trailer connector. Keep in mind, that the center pin of the connector installed on the vehicle will need to be tied in to the reverse light circuit so it gets power when the transmission is shifted into reverse.
The specs you mentioned on your existing solenoid are exactly like the Titan part we offer.
Because of their location, the solenoids are subject to being damaged if somebody steps over the trailer tongue and they aren't careful. A shield is available to protect the solenoid, part # T4836100183.
Products Referenced in This Question
Solenoid Shield for Dexter Model 10 and Model 20 Trailer Brake Actuators - Zinc
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Solenoid
- Shield
- Dexter
more information >
Product Page this Question was Asked From
Replacement Solenoid Valve for Dexter Brake Actuators with Reverse Lockouts
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Solenoid
- Valve
- Dexter
more information >
Continue Researching
- Video: Hopkins 7-Way Molded Trailer Wire Connector Review
- Video: Hopkins 7-Way RV Style Molded Cable Connector Review
- Video: Hopkins Wiring - Trailer Connectors - H20043 Review
- Search Results: break lines
- Search Results: surge brake reverse solenoid
- Search Results: break away cable
- Shop: Trailer Wiring Junction Box
- Shop: Hydrastar Marine Electric Over Hydraulic Actuator w/ Breakaway and 7-Way RV Harness - 1,600 psi
- Shop: Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
- Shop: 7-Way Molded Trailer Wire Connector, 4' Long
- Shop: Hopkins 7-Way Molded Trailer Wire Connector - 11' Long
- Search Results: 44649
- Shop: Trailer Hitch
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Video: Aries AdvantEdge Headache Rack Review
- Article: Trailer Wiring Diagrams
- Shop: Grease Seals 10-36 (pair)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Shop: etrailer Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 5,200 lbs to 7,000 lbs
- Video: NOCO GEN On-Board AC to DC Battery Charger Review
- Search Results: 25580
- Video: etrailer Magnetic Hitch Receiver Reducer Sleeve Review
- Shop: Fifth Wheel Hitch
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Search Results: 68149
- Article: Trailer Tire Sizing
- Video: Choosing the Right Trailer Wiring
- Search Results: dust cap
