Replacement Landing Gear for 2002 Carriage Cameo F34CK3 5th Wheel Trailer  

It looks like you will need to have your current brackets removed and have new ones welded on since none of the landing gear sets we offer are designed for brackets that are 15 inches apart. Any qualified welder could do this for you and would not…

I have a few different options for you depending on the route you would like to take. However, regardless of which route you pursue you will need to take some measurements of your outer jack tube length and weld stop spacing. If you are handy and…

In order to determine the correct replacement landing gear for your 2010 Keystone Outback 285FL, I would just need to know what the measurement between the mounting brackets on your trailer from outside to outside, and choose the amount of lift and…

It sounds like the landing gear on your Fuzion Toy Hauler may have been overextended, which likely caused damage to the internal gears and screw. This "flopping" that you mentioned is essentially the unit trying to extend but since the…

If there isn't a brand name printed on a tag somewhere on the actual landing gear it is not easy to determine because they all look and function the same way. The nice part about that is that if you need to replace parts or complete systems they…

The standard replacement for the 5500-rpm landing gear motor 125340 that is used on Stromberg Carlson #LG-1 and #LG-2 landing gear is our part #LG-142178.

The dimension of 15-1/2 inches between the brackets on your landing gear means nearly every landing gear set is going to fit your trailer as that is the standard dimension. For a powered Lippert landing gear that would bolt right up we have the part…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…