Hyperflash On 2009 Ford Flex After Installing Trailer Wiring
Question:
Purchased a Tow Ready T-one connector assembly for my Ford Flex and when connected to trailer the left blinker flashes too quickly like a bulb is burnt out. Bulb is fine. Not sure what is causing problem. I see you had a couple customers comment on similar issue. Any recommendations?
asked by: Tim
Expert Reply:
It sounds like you have a hyperflash condition with your 2009 Ford Flex. LED lights will flash like that because they do not provide enough power draw for the system to recognize them and the vehicle bulb-out sensor thinks there is a bulb out on the circuit.
You should start by reinstalling the T-One to make certain all connections are seated properly and not causing the problem.
If all of the connections are good and you have LED lights on your trailer, you may need Diamond LED Light Bulb Load-Resistors # DI34ZR to prevent hyperflashing of the blinkers.
I have attached installation instructions you can check out.
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Shop: Combination Trailer Tail Light - 7 Function - Incandescent - Square - Red Lens - Driver Side
- Shop: Optronics Combination Trailer Tail Light - 6 Function - Incandescent - Red Lens - Passenger Side
- Video: Review of Diamond Lights - Load Resistors - DI34ZR
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Troubleshooting LED Trailer Lights that Flicker When Vehicle is Off
- Shop: Trailer Hitch
- Search Results: 118746
- Q&A: Load Resistors For Recognizing Trailer Lights
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2021 Mazda CX-5
- Q&A: Troubleshooting Blinkers Hyper-Flashing on a 2007 Mitsubishi Outlander after Trailer Wiring Install
- Q&A: Left Blinker Flashes Fast After Installing Trailer Wiring Harness on a 2014 Chevy Camaro
- Q&A: Troubleshooting Blinker Hyperflash On 2019 Ford Edge Titanium After Shop Installed Trailer Wiring
- Q&A: Troubleshooting Right Turn Signal Flashing Twice as Fast As Other After Harness Installation
- Q&A: Does Wiring Harness on 2019 Mazda CX-5 Have to Get Power From 12V Battery
- Video: Review of CURT Electrical Tools - 5 Way Flat Circuit Tester - C46NR
- Video: etrailer Trailer Hitch Installation - 2022 Mazda CX-5
- Video: Curt Fusion Ball Mount Review C45152
- Shop: Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens - Qty 1
- Shop: Curt Fusion Ball Mount for 2" Hitches - 2" Ball - 2-1/4" Rise - 7,500 lbs
- Search Results: 003 30
- Video: Optronics Combination Trailer Tail Light Review and Installation
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Trailer Wiring
- Search Results: trailer hitch
- Search Results: hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer lights
on Accessories and Parts
