Is There Brake Controller Wiring Harness Present on 2008 Winnebago Voyage 33V

Question

Question:

I have a 2008 Winnebago Voyage 33V on a Workhorse Chassis. I am looking for a brake trailer control with wiring harness. Can you help me?

asked by: Wayne B

0

Expert Reply:

Hey Wayne, so it looks like your 2008 Winnebago Voyage 33V is built on the Workhorse W22 chassis which has brake controller wiring present under the dash but it's just a wiring harness and does not have a connector that a harness could plug into.

The harness is located up under the dash and to the left of the steering column. Look for a bundle of wires held together with a white tag. The tag shows the functions of the wires.

On the brake controller white is ground, black is 12 volt power, red is stoplight, and blue is output ran to the brake output circuit.

expert reply by: Jameson C

0

Answer 1

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 4

For your 2024 Chevy Silverado 1500 I recommend the Redarc Tow Pro Elite #RED63RR. You can use it along with the Plug in Adapter #3064-P for a plug and play install, since you already have the factory tow package. The Redarc controller is going to be…

view full answer...

Answer 5

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 6

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

All the brake controller needs to sense a trailer connection so that you can test it is a slight amperage draw on the output circuit. For that you can use a circuit tester like the part #PTW2993 with one pin grounded and the other on the output pin.…

view full answer...

Answer 9

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

view full answer...

Answer 10

For your 2024 Nissan Frontier I recommend the Redarc Tow-Pro Liberty Brake Controller #RED24FR. I like the Liberty because it is simple, reliable, and looks great in any vehicle. The main unit installs behind the dash, so only the control knob will…

view full answer...

Answer 11

You are correct, you should only be getting output when the brake is applied, or the override switch is activated. It sounds like the controller might be bad, but to make sure, you should probably bench test it before tossing it. Use a circuit…

view full answer...

Answer 12

The Prodigy P3 trailer brake controller uses a 4-wire hookup. The white wire is to be grounded to the battery negative terminal; the black power wire connects to the battery hot terminal through a circuit breaker; the red wire takes in the brake…

view full answer...

Is There Brake Controller Wiring Harness Present on 2008 Winnebago Voyage 33V

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching