Is There a Difference Between The Progressive Dynamics PD1620A and Your Part # PD64FR?

Question

Question:

Can you please tell me the difference between a PD64FR and a PD1620A?

asked by: Edward M

0

Expert Reply:

The Progressive Dynamics 2000 Watt Inverter w/ Transfer Switch # PD64FR is simply our part number for the PD1620A. We do not always use the manufacturers part numbers as our own since we have so many different manufacturers we carry.

expert reply by: Bud M

0

Answer 1

What you need is a splitter or dual adapter like part #MBS54FR and this will work for you as long as your tank's connector is threaded on the inside not just the outside. If it's threaded both in and out that's okay too…

view full answer...

Answer 2

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better…

view full answer...

Answer 3

There is a suggested and common method for 6 function trailer wiring. You will have the following functions: Right Turn, Left Turn, Ground, Tail/marker, Brake, Battery. I have included a help article on trailer wiring that includes a diagram and…

view full answer...

Answer 4

On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 7

I spoke with Lippert and they said the Kwikee 35 Series Electric RV 1-Step part #LC3691461 will be a direct replacement for the Coach Steps 725-0041. It will be a bolt-on install for the most part for the exception of changing out the door switch…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Is There a Difference Between The Progressive Dynamics PD1620A and Your Part # PD64FR?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching