Size Of Front Hitch Receiver Opening For 2011 Toyota Tundra  

There is a 4 inch diameter hole that needs to be cut in the skid shield of your 2016 Toyota Tundra to be able to install the Draw Tite front hitch part #65080 that you referenced. I attached a diagram that shows where it will be.

Starting with the tow hooks, those will remain on your 2020 Toyota Tundra when installing the Draw-Tite Front Mount Trailer Hitch Receiver #65080. They will be temporarily removed, but will be bolted back on. In regards to the hole, there is a small…

I reached out to Curt directly and was informed that on your 2020 Toyota Tundra TRD you will need to either remove the tow hooks, or will need to purchase longer bolts if you would like to retain the tow hooks when installing the Curt Front Mount…

There is a way to find where the end of the hitch receiver will sit once installed on your 2011 Toyota Tundra, but we have not had a chance to install the Curt Front Mount Hitch, #31198, on a 2011 Toyota Tundra yet, so I do not have a specific…

For your 2018 Toyota Tundra the recommended front hitch is the part #31198 for use with the Agri-Cover SnowSport plow part A40000HD. You will need to enlarge a hole in the skid plate to allow the install of this hitch while also allowing easy access…

On the Curt front mount receiver #31198 there is a note stating that the skid shield will either have to be removed or you can trim it and reinstall in on your 2018 Toyota Tundra. For the Draw-Tite receiver #65080 we have a note stating that the skid…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…