Is There a LED Trailer Light Strip For Brakes, Turn Signals, and Tail Lights

Question

Question:

I am looking for a 4 function min 21 LED red light bar 1. Tail lights 2. Rt turn 3. LT turn 4. Brake It is for top of cargo trailer on back.

asked by: Ray R

0

Expert Reply:

We have two strip lights that function as brake lights, turn signals, and tail lights, depending on the length you need (I wasn't quite sure what you meant by "min 21" which is why I'm listing both options):

- 12-5/8" long: Thinline LED Trailer Tail Light # STL59RB

- 20-1/2" long: Thinline LED Trailer Tail Light # STL64RB

expert reply by: Kyle S

0

Answer 1

The video review for the Optronics Thinline LED Trailer Tail Light #STL64RB that you mentioned is correct. The white wire is for ground, the black wire is for tail lights, and the red wire is for turn/brake signals.

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

For a made in the USA aluminum ball mount we only have adjustable units like the Flash Secure 2-Ball Mount #DTSTBM6600-2S which includes stainless steel hitch balls as well. The Fulton #F97CR you found as well as the similar Curt #C74WR and Brophy…

view full answer...

Answer 5

The Grease Seal part #168233 has a double lip so it can be used on a boat trailer and be submersed under water, yes. This is also the correct replacement for the NOK AD2527E Grease Seal that you have now.

view full answer...

Answer 6

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 7

According to my contact at Tekonsha, the connector you're looking for will only be present if the bumper sensors are dealer-installed. If the parking sensors were factory installed, the connector will NOT be present, and the blue wire in question…

view full answer...

Answer 8

Easiest solution for that would be the Curt auxiliary LED indicator lights part #C53201. This would allow you to add stoplight/turn signals to your bike rack and it plugs into a 4-way like you mentioned.

view full answer...

Answer 9

The 195/70R14 tire is a passenger car tire size. A trailer should have a ST rated tire. which means it is a Special Trailer tire. The special trailer tire is designed with stronger sidewalls and can handle higher air pressures which are needed when…

view full answer...

Answer 10

The left side is the driver side, right side is passenger side. On a trailer brake assembly like #23-105 the arm that the magnet is on points to the front of the trailer and the magnet always will be on the bottom. I have included a picture that…

view full answer...

Answer 11

It's definitely possible to upgrade a trailer's axle rating to a higher rating by just swapping the axles. To pick out the correct axle you'll need to measure the distance between the hub faces and the spring seat centers and you'll…

view full answer...

Is There a LED Trailer Light Strip For Brakes, Turn Signals, and Tail Lights

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching