Does The Trailer Valet JXS Trailer Jack # TV34FR Need Greased From The Factory?

Question

Question:

Do I need to grease the Jack before using it or does the jack greased at the factory before delivery?

asked by: Kim P

0

Expert Reply:

The Trailer Valet JXS Trailer Jack # TV34FR will come already lubricated. It is recommend to grease the internal gear system every 90 days.

expert reply by: Bud M

0

Answer 1

I would be happy to! The bottom of the foot to the center of the pipe mount is 10-1/2" when retracted and 24-1/2" when fully extended on the Trailer Valet JXS Trailer Jack w/ Footplate and Drill Powered Option item #TV64FR. Sorry I do not…

view full answer...

Answer 2

When fully retracted, or collapsed the jack is 28.58 inches tall, and 38.42 inches tall when extended as shown in the provided diagram. I've linked you to a product description video featuring the #ORJW1SU ARK Extreme Off-Road Ratcheting Trailer…

view full answer...

Answer 3

The mounting bracket for the #TV34FR is actually identical to the bracket on the #TV64FR that you were looking at. The holes are 1" apart on center vertically, and 5-1/2" apart horizontally. I have attached a picture for your reference.

view full answer...

Answer 4

I will start by saying the ARK Extreme Off-Road Ratcheting Trailer Jack w/ Wheel #ORJW1SU will fit frames that are 2" to 6" tall. The bolt hole measurements vary and I included a diagram with everything listed, but the overall dimensions of…

view full answer...

Answer 5

The only difference in the Demco Channel Tongue Trailer Couplers #DM16080-95 and #DM15931-95 is going to be the bolt pattern. One will have the 5-Bolt hole pattern and the other is going to have 4-Bolt holes. I have included images below showing the…

view full answer...

Answer 6

Thank you for the image. It appears you will need either the Demco Channel Tongue Trailer Coupler #DM13203-95 or #DM16080-95. Both of these couplers have a zinc coating for increased corrosion resistance and fit on a standard 3" wide channel…

view full answer...

Answer 7

Yes, you can use 2 of the Timbren Axle-Less Trailer Suspension Kits #ASR35HDS02 which will give you a total trailer GVWR of 7,000lbs. Do understand you must include the weight of the trailer into this calculation. If you are needing to carry 7,000lbs…

view full answer...

Answer 8

Hey Antoine, so the two kits you mentioned are actually really similar and honestly I would go with the part #ETBC7 if I were you. The #ETBC7L is basically the same thing minus a couple wires and breakers so you may as well get the kit that has…

view full answer...

Answer 9

The Dutton-Lainson Square Swivel Jack #DL22340 has a mounting plate designed to fit trailer frames with a height of 3" - 5". I have attached a dimensional drawing below with all of the bolt spacing for your reference.

view full answer...

Answer 10

The #BK2-100 Bearing Kit for #84 Spindle L44649/L68149 Bearings 10-19 Double Lip Seal will work. You have EZ Lube spindles which do not use a cotter pin. The spindle has a tube in it for the grease to be pumped in. Instead it uses a tang washer,…

view full answer...

Does The Trailer Valet JXS Trailer Jack # TV34FR Need Greased From The Factory?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching