Recommended Timbren Silent Ride Suspension System for a 14K Tandem Axle Livestock Trailer  

The maximum deflection or compression/movement of the Timbren Silent Ride Suspension for Tandem Axle Trailers #TSR14K35T01 is 1-5/8 to 1-7/8 inches. That's the amount it will move from zero load to full compression.

The Timbren Silent Ride Suspension for Tandem Axles, #TSR14KT01, was designed to eliminate the problems that traditional leaf spring trailer suspension encounter on travel and 5th wheel trailers. (The Silent Ride system will bolt right up to the…

You will need to use the Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shocks #RM-2460-2580 for upgrading the suspension on your 2019 Crossroads Redwood 3951WB Fifth Wheel Camper. This kit is rated for your 8,000lb axle and the springs have…

The review you mentioned does have a customer of our having to install a 4 inch sub frame spacer to install the Timbren #TSR14K35T01 like you mentioned to accomplish the same ride height as their previous straight axle setup. But worth nothing is…

A Timbren Axle-Less system or Silent Ride system would definitely upgrade the stock leaf spring set up on any camper or trailer. That being said, there are a couple things to keep in mind when choosing one of these systems.. The Timbren Axle-Less…

Correct, the Timbren Silent Ride Suspension for Tandem Axle Trailers part #TSR14KT01 is designed for 7,000 lb axles as the total capacity is 14,000 lbs. It is also designed for a 33" axle spread. If you have a 35" axle spread…

The Timbren Silent Ride #TSR14KT01 can actually be installed by welding it on or bolting it on. You could do both welding and bolt it on, but that is not really necessary. I am not sure of the bracket to move it around on the frame, but they do…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have…

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind…

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65…