Measurements For Equal-i-zer Replacement L-Pin # EQ95-01-9430

Question

Question:

What are the measurements for this pin?

asked by: Roy R

0

Expert Reply:

I edited a picture to show measurements for this Replacement L-Pins # EQ95-01-9430. This pin will work with Equal-i-zer weight distribution systems rated for 6,000 lbs - 14,000 lbs GTW. I hope this helps.

expert reply by: Jesse M

0

EQ95-01-9430 Dimensions
(click to enlarge)

Answer 1

We've checked with Solera in the past about this same issue where the top arm of the awning support arm becomes bent and they have told us that individual part is not replaceable so you'd need to replace the entire assembly with the part…

view full answer...

Answer 2

The B and W Companion hitch part #BWRVK3305 that you referenced weighs 159 lbs. The head is easily removed to make the install and removal of the hitch easier as well since it splits the weight up. The head weighs 71 lbs.

view full answer...

Answer 3

I have a different option for you, but the Replacement Spring Bar Retainer #BLU25QR you were looking at is not confirmed to fit your Fastway e2 Weight Distribution Hitch. Instead you will need either the #FA92-03-9460 if you have the 4500lb system,…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

Answer 7

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 8

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 9

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 10

Hey Jay. It sounds like you are on the right track here because a sidewinder pin box will be your only option for pulling your 5th wheel since you have a short bed truck with the Rambox. That said, you are right that the Reese Sidewinder cannot be…

view full answer...

Answer 11

Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they look like the rails of the #RP30035 that you referenced they would be the industry…

view full answer...

Answer 12

There should be a sticker or plate on the pin box itself that lists the manufacturer and model of the pin box. If it is not present then there are some measurements you can take to determine the model of the pin box. I have included a link that…

view full answer...