Can Trailer Lighting with Three Wires Replace Two Wire Setup
Question:
Hi, I had previously posed question for switching from incandescent fixtures to LED on a car hauler. The fixtures on the web page show 3 wire design, but my incandescents are 2 wire, what do I need to do? Thanks
asked by: Jerry
Helpful Expert Reply:
Trailer taillight kits like the part # TLL56RK that have 3 wires can install on trailers that have 2 wire setups pretty easily. What you would need to do is run the white wire of this kit to the mounting hardware and you'd be set. What you have now is designed to ground through the mounting hardware so with kits like this it would be just a matter of running the ground to the same place.
Product Page this Question was Asked From
LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Reflector
- Stop/Turn/Tail
- Rectangle
- Kit
- Surface Mount
- Submersible Lights
- LED Light
- 6L x 3-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Search Results: grease gun
- Q&A: How to Find Correct 4 on 4 Replacement Hub
- Shop: Easy Grease Trailer Idler Hub Assembly for 2K Axles - 4 on 4 - Pre-Greased
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - Galvanized
- Shop: CE Smith Carpeted Bunk Boards for Boat Trailers - 6' Long - 1 Pair
- Shop: Submersible, Under 80" Trailer Light Kit with 25' Wiring Harness
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - Galvanized
- Shop: LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Shop: 25 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 25' Ground
- Q&A: Troubleshooting Newly Installed LED Combination Tail Light Kit TLL56RK Not Working
- Q&A: Installation of CE Smith Boat Trailer Bunk Boards CE27840 and Swivel Brackets CE10000G-4
- Q&A: Does Boat Have to Be Off Trailer to Install New Boat Bunk Boards
- Search Results: super lube
- Q&A: Could Zerk Fitting be Added to Trailer Spindle to Make it an EZ Lube Spindle
- Q&A: Can You Install an EZ Lube Hub and Drum on a Non EZ Lube Axle
- Q&A: How to Add Grease to Super Lube Trailer Hub with Rear Grease Zerk Fitting
- Search Results: l44649
- Shop: Trailer Hitch
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Search Results: 25580
- Shop: Trailer Wiring
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Search Results: safety chains
- Article: Trailer Tire Sizing
- Shop: Brake Controller
- Search Results: bearing buddy
- Video: etrailer Electric Trailer Brake Kit Installation
- Shop: Gooseneck Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Trailer Lights
