How to Wire in a Brake Controller in a 2005 Holiday Rambler Endeavor
Question:
Where do you tie the signal wire for the Prodigy2 controller in on the coach? i read in another post about a wire marked brake sig from control box 3 but that was an older model.i know where to tie in the other wires just need to fiqure out the sig wire.
asked by: John P
Expert Reply:
The brake wire you need is terminated in a connector under the left side control panel next to the driver seat of your 2005 Holiday Rambler Endeavor. There should be a cover on the vertical side of the panel facing the driver seat and the connector will be behind it. There should be a 12 volt power wire (run black wire here), a ground wire (white wire), a brake switch wire (red wire) and a brake output circuit (blue wire) there.
I attached an FAQ on brake controller installs for you to check out also.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller Installation: Starting from Scratch
- Video: Roadmaster Brite-Lite Wiring Converter Installation - 2003 Fleetwood Discovery Motorhome
- Shop: Vehicle Tow Bar Wiring
- Shop: Hopkins Endurance Quick-Install 7-Way Trailer Connector with Universal Pigtail Harness - Vehicle End
- Shop: Roadmaster Brite-Lite Wiring Converter
- Shop: Hook Probe Circuit Tester
- Shop: Windshield Wiper Blades
- Shop: Scrubblade Platinum Windshield Wiper Blade - Hybrid Style - 20" - Qty 1
- Search Results: utility box
- Search Results: 3500
- Search Results: ej~3520~bbx
- Shop: Brake Controller
- Search Results: recpro
- Q&A: Installing a Brake Controller in a 2002 Holiday Rambler Endeavor
- Shop: Fulton XLT Powered Drive Trailer Jack - Drop Leg - Side Mount - 22" Lift - 2,500 lbs
- Shop: Trailer Wiring
- Shop: UWS Large Tote Storage Box - 1.3 cu ft - Bright Aluminum
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Tekonsha P3 Brake Controller 90195 Displays Message Output Shorted No Brakes
- Q&A: Troubleshooting a Tekonsha P3 Brake Controller that Reads Trailer Not Connected
- Q&A: Brake Controller Recommendation for 2007 Holiday Rambler Endeavor
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2019 Buick Encore
- Q&A: Installing A Brake Controller On A 2000 Holiday Rambler Admiral
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Lack of 12V Power at 7-Way Trailer Connector on 2019 Ford F-150
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Vehicle Tow Bar Brake System
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Choosing the Right Trailer Wiring
on Accessories and Parts
