Heating Element Location on a Dometic RV Water Heater

Question

Question:

Where is the electric heating element located on Dometic hot water heater ?

asked by: Lyndon K

0

Expert Reply:

I spoke with Dometic, and they let me know that the electric heating element on the Dometic RV Water Heater # DMC74FR is located behind the circled access panel.

expert reply by: Bryce D

0

Heating Element Location
(click to enlarge)

Answer 1

I do have an option for you but the inner tank for the Atwood GC6AA-7 is no longer available but we do have a full replacement option for you in the Dometic RV Water Heater part #DMC74FR. This unit should be a direct replacement featuring a 6 gallon…

view full answer...

Answer 2

For your 2004 Itasca Suncruiser, with an Atwood RV Water Heater w/ Heat Exchange AT94023, which is no longer available, I recommend going with the Dometic RV Water Heater #DMC74FR. This tank is a bit smaller at 6 gallons, versus AT94023 10 gallon…

view full answer...

Answer 3

The Furrion RV Tankless Water Heater #FR68SR is currently the only water heater we have for replacing your Atwood GCH10-3E. This tankless water heater has an 18" x 18" door which will fully cover the cutout and old door on your 2002…

view full answer...

Answer 4

I do have an option for you. But I can tell you that the feature you have with the hose coming from the engine through the water heater is no longer available. Since you are needing to replace your GCH10A-3E water heater, I recommend going with a…

view full answer...

Answer 5

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 6

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 7

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 8

I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be 3/8" shorter but that is still close…

view full answer...

Answer 9

For a standard replacement equalizer for your Dexter 13-122 equalizers you'd want the #TREQE1 or for a cushioned version you'd want the part #K71-653-00 which comes with new shackles and bolts. For a kit that includes new bolts, bushings, and…

view full answer...

Answer 10

The correct replacement for an Atwood Water Heater GC6AA-9E is the Dometic RV Water Heater part #DMC74FR. This is a 6 gallon water heater that works with both gas and electric just like the one you have so it will be an exact match.

view full answer...

Answer 11

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 12

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...