Replacement Shroud for Dometic Brisk Air II AC Unit

Question

Question:

I have a Dometic Roof top AC unit that i need a replacement cover. I bought the travel trailer new in 2014 and the Dometic tag shows a SKU# of 9105304464 What cover do i need?

asked by: John T

1

Helpful Expert Reply:

Based on the SKU number you mentioned what you have is a Dometic Brisk Air II which the part # DMC46FR is the correct replacement shroud for.

expert reply by: Jameson C

1

Answer 1

Since you have the Dometic Duo-Therm air conditioner, the correct replacement shroud for you is the: -Replacement Shroud for Dometic Duo-Therm RV Air Conditioner #DMC69FR. Attached is a product overview video for you to check out.

view full answer...

Answer 2

The 3107541.009 is the part number for the analog control kit for the Dometic Duo-Therm on your 2010 Keystone Bullet. Based on the information we have it does appear as though the #DMC69FR you looked at is the correct replacement. However, without…

view full answer...

Answer 3

Since you have a Dometic Duo Therm RV AC unit the correct replacement shroud is the part #DMC69FR.

view full answer...

Answer 4

The Quick Cool label on your shroud there is a sticker Dometic put on a bunch of different models. From the picture, it looks nearly identical to the #DMC69FR. The dimensions for this shroud are 34-1/2" long x 30" wide x 10-3/4" tall.…

view full answer...

Answer 5

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 6

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 11

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 12

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Replacement Shroud for Dometic Brisk Air II AC Unit

Product Page this Question was Asked From

Continue Researching