How Much Wall Clearance Does UWS A-Frame Tool Box UWS01065 Require

Question

Question:

How many inches of clearance is required between the trailer front wall and this box for the lid to open fully? Id like to mount the box as close to the trailer as possible without lid interference.

asked by: Jacob T

0

Expert Reply:

There needs to be 2 inches of clearance between the UWS A-Frame tool box part # UWS01065 and the wall it mounts in front of to allow the lid to open fully.

expert reply by: Jameson C

0

Answer 1

If you're looking for heavy duty and don't mind it weighing more on your trailers tongue, then I recommend going with a steel toolbox for your trailer like the RC Manufacturing T-Series Trailer Tongue Tool Box - A-Frame - Steel - 5.2 Cu Ft -…

view full answer...

Answer 2

The DeeZee Specialty Series Trailer Tongue Tool Box #DZ91717 is 0.056" thick. The UWS A-Frame Trailer Toolbox #UWS01065 is 0.058" thick.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Waylon, it does look like the Dexstar Steel Mini Mod Trailer Wheel #AM20539 is the same thing as the Dexstar 17-233 wheels you're referring too. These are silver wheels with a 6 on 5 1/2 bolt pattern, a 0 offset, and are made in the USA.

view full answer...

Answer 5

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 6

I see what you mean with the additional support bracket below the frame on your 2024 Keystone Hideout Sport 175BH travel trailer. I'm glad you reached out to us Peter as that is going to limit you on what you can use. With that additional…

view full answer...

Answer 7

Yes, the Kodiak 13" Rotor #KR13858D will fit your Dexter hub and work with your existing Kodiak Calipers #KDBC250D. This is assuming you have an 8 on 6-1/2 bolt pattern, which I'm sure you do, and your wheel size is 16" or larger.

view full answer...

How Much Wall Clearance Does UWS A-Frame Tool Box UWS01065 Require

Product Page this Question was Asked From

Continue Researching