Is SeeLeveL RV Holding Tank Monitor Availabile With the Sensors

Question

Question:

Is this available in a kit with the sensors or do I have to get those separately?

asked by: Julia

0

Expert Reply:

Yes, to get the SeeLeveL RV Holding Tank Monitor # SE34VR with the sensors you need the SeeLeveL RV Holding Tank Monitoring System # SE59VR.

This comes with the same monitor along with 3 of the 12" long sensors you install on plastic tanks.

expert reply by: Jon G

0

Answer 1

We have the 710-AR and 710-ES2 SeeLevel sensors, though I was unable to find any 701AR or 701ES2. If you were referring to the 710-AR and 710-ES2 you would need the following: - 710-AR: SeeLeveL Sensor #SE88VR - 710-ES2: SeeLeveL Sensor #SE78VR

view full answer...

Answer 2

With your trailer not currently measuring propane levels, I would recommend going with the SeeLeveL RV Holding Tank Monitoring System #SE39VR which comes with the water pump switch. The reason for that is because the SeeLeveL RV Holding Tank…

view full answer...

Answer 3

Depending on where you install it on your RV yes, the Hopkins Never Fade Trailer Bubble Level Set #HM08526 that you referenced can be read in a rear view mirror.

view full answer...

Answer 4

I spoke with my contact at BOLT and he said for security reasons all BOLT Locks permanently learn the first key used in them and cannot be reset. BOLT recommends users sell the locks with their vehicle and purchase a new set of locks with their new…

view full answer...

Answer 5

I reached out to my contact at Timbren and this is something that is not all that uncommon. If the brake lines on the axle of your 2013 F53 Chassis are underneath the Timbren Rear Suspension Enhancement #TFRF53A you can carefully bend them out of the…

view full answer...

Answer 6

Yes we do carry the SeeLevel brand of tank sensors and monitors. If you check out the link I attached to this page you'll see all of the options we offer.

view full answer...

Answer 7

While we do have the stick-on graduated levels, each of them are in the 3 to 4 inch range like you mentioned and there aren't any that are larger. So the trade off of getting something like the 10 inch Camco AccuLevel Trailer Bubble Level…

view full answer...

Answer 8

That part number corresponds with a SeeLevel system that has sensors for a fresh, gray, and black water tank like the part #SE39VR but we do not have the version that has the NMEA2000 interface.

view full answer...

Answer 9

The most cost effective option for air bags on your 2023 Ranger is going to be the Air Lift LoadLifter 5000 Air Helper Springs item #AL57234. These air bags have a 5,000 lbs capacity that will level out the rear end of your Ranger when you are towing…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Is SeeLeveL RV Holding Tank Monitor Availabile With the Sensors

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching