How to Identify The Correct Replacement Hydraulic Motor For a 2002 Gulf Stream Sun Voyager

Question

Question:

We are looking for a hydraulic motor for a 2002 Gulf Stream SunVoyager. The jacks will not work and the main slide out is on borrowed time.

asked by: Steve W

0

Expert Reply:

To help you find the correct replacement hydraulic motor for your 2002 Gulf Stream Sun Voyager I will need you to get any part information off the motor you can find. There is no way for me to look up what the manufacturer put on your motorhome from the factory as they are not required to record this information like automobile manufacturers. Please send us any information you can find either part numbers on the unit or photos of the unit which may help us to verify the correct replacement.

expert reply by: Bud M

0

Answer 1

Just the solenoid of the Replacement Hydraulic Pump Motor for Lippert Hydraulic Power Unit #LC167576 is not available so if you need just the solenoid you'd need the entire #LC167576.

view full answer...

Answer 2

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point…

view full answer...

Answer 3

To replace the Level Up controller on your 2012 Dutchmen Infinity 3750FL you need the Replacement OneControl Advantage Controller #LC88TF. I confirmed this is what you're needing with my contact at Lippert!

view full answer...

Answer 4

There may be a bunch of different reason why your Lippert Level-Up system has suddenly stopped working. The most common reasons are due to a dead battery, extending your jacks too far, or a blown fuse. The first thing you should check for is the…

view full answer...

Answer 5

When your Lippert Ground Control 3.0 #LC358590 has a reading that says "Comm Error" it is referring to the communication between the controller and touch pad. You will need to check your harness to ensure it is connected properly…

view full answer...

Answer 6

If your current touch pad is broken, there isn't a way to just replace the button and get a working control panel, so you would need a new one. I verified with Lippert that the correct replacement for your panel with the manufacturer number 12478…

view full answer...

Answer 7

If you have the module part #LC175226 the correct replacement touch panel would be the #LC421484.

view full answer...

Answer 8

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 9

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 10

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 11

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 12

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

How to Identify The Correct Replacement Hydraulic Motor For a 2002 Gulf Stream Sun Voyager

Product Page this Question was Asked From

Continue Researching