Recommended Rear Anti-Sway Bar For A 2006 Dodge Ram 3500 With A TorkLift SuperHitch

Question

Question:

I have a 2006 Dodge Ram Megacab 3500 short bed 4x4 5.9 diesel and I am looking to purchase a rear anti-sway bar that will work with the Torklift superhitch 20K. I have been doing research and found that there maybe challenges with certain rear anti-sway bar assembly when there is a Torklift superhitch receiver installed. I need to confirm which brand of an anti-sway bar would work. Thank you,

asked by: Bo C

1

Helpful Expert Reply:

According to Roadmaster having a TorkLift SuperHitch would not impede the installation of their anti-sway bars. For a 2006 Dodge Ram 3500 4WD you'll need the Roadmaster Rear Anti-Sway Bar # RM-1129-124.

expert reply by: Kevin C

1

Answer 1

The Roadmaster Rear Anti-Sway Bar #RM-1129-124 is going to install away from the air bags so you shouldn't have any issues have both installed on your 2006 Dodge Ram 2500. I actually found a customer submitted photo showing the two…

view full answer...

Answer 2

Yes the Roadmaster Rear Anti-Sway Bar part #RM-1129-124 is a fit for your 2015 Ram 3500 and does fit with Air Lift air bags #AL57295.

view full answer...

Answer 3

To get the B&W Patriot #BWRVK3200 to work with your 2006 Dodge Ram you're going to need a set of 5th wheel rails #DM8552016-71. These rails are custom fit to your vehicle so they'll just bolt right up to the frame. It is worth…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Yes you are - all 5th wheel hitches are going to require some type of rails in order to be used. So you'd need #DM8552016-71 for your 2006 Dodge Ram.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

The best fixed fifth wheel hitch we offer for your 2019 Ford F-250 with the factory fifth wheel prep package is the USA B and W Companion Hitch part #BWRVK3200. The Companion hitches are widely regarded as the best fifth wheel hitches on the market…

view full answer...

Answer 11

The side plates of the B&W gooseneck trailer hitch #BWGNRK1313 will mount on the outside of each frame rail of your 2004 Dodge 2500 8-foot bed. See the B&W video I included at the 7 min and 30 second mark. If your Firestone air bags like…

view full answer...

Answer 12

Looks like you'd be good. I pulled up the towing capacity of your truck and it's rated for 15,350 lbs trailer weight and your trailer would weigh at most 12,995 lbs. The M5 Series hitch part #RP30928 that you referenced has a 20k capacity and…

view full answer...

Recommended Rear Anti-Sway Bar For A 2006 Dodge Ram 3500 With A TorkLift SuperHitch

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching