Availability of Air Lift Air Bag Kit that Fits 2012 Toyota Tacoma

Question

Question:

For my 2012 4WD Toyota Tacoma, is there a reason why I cant use the 5000 Ultimate with the internal jounce bumper? Id like to have that just in case I lose air pressure completely.

asked by: Douglas B

0

Expert Reply:

Air Lift has air bag suspension enhancement kits that fit your 2012 Toyota Tacoma 4WD like the part # AL49DQ but they do not offer a version that has the internal jounce spring. Some report that the jounce spring versions make the ride quality harsher so it would not be my favorite option to recommend.

expert reply by: Jameson C

0

Answer 1

Yes, it will but you may need a spacer. The reason I say may is most 3" lifts are not 3" in the rear. If your 2013 Toyota Tacoma has less than a 2" lift in the back then all you will need is the Air Lift LoadLifter 5000 Air…

view full answer...

Answer 2

When installing the AirLift 1000 Helper Springs #AL60811, you want to install the spacers at the bottom of the air bag. The original spacer that is included in your kit will be used in combination with the Air Lift Universal Air Spring Spacers for…

view full answer...

Answer 3

If you are looking for a suspension lift for your truck we don't have anything that will work for you. The suspension enhancement kits we offer like the Firestone kit part #F2407 are designed to support the rear suspension of a truck that…

view full answer...

Answer 4

There is not a recommended psi level when using Firestone Ride-Rite Air Helper Springs #F2709 with the exception the minimum 5 psi and maximum 150psi. It sounds like 70 psi gets you to level, which is ideal for towing. If 100 psi is more…

view full answer...

Answer 5

I highly recommend going with the Air Lift LoadLifter 5000 Air Helper Springs #AL49DQ over their Ride Control system for your 2023 Toyota Tacoma 4WD because they not only offer more support, but they also have a better construction so…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Availability of Air Lift Air Bag Kit that Fits 2012 Toyota Tacoma

Product Page this Question was Asked From

Continue Researching