Where to Mount RM-15267 Wiring on 2003 VW New Beetle

Question

Question:

Can you send me picture of where you recommend mounting 6 pin receptacle on my 2003 new VW Beetle. Have installed base plate BX3818....Have tow bar BX7322.... and am read to install wiring kit RM 15267. Does not appear much room for it center of car.

asked by: Walter B

0

Expert Reply:

We do not have any type of photo available that I can offer, but you should be able to mount the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit # RM-15267 just to the side (on the left or right, your choice) of where the arms protrude on the grille of your 2003 VW Beetle.

expert reply by: Kyle S

0

Answer 1

It sounds like you do not have an S or non-Turbo S model Beetle. The Turbo S Beetles come with a 1.8 liter turbo motor and a speed activated rear spoiler. You would probably know this already if you had an S model. The Roadmaster Base Plate Kit…

view full answer...

Answer 2

It's generally accepted that all vehicles with a manual transmission can be flat towed. That said, I did some checking and for your 2013 Volkswagen Beetle if you have the 2.0 liter engine then it is not recommended by VW but if you have have the…

view full answer...

Answer 3

For a base plate kit to flat tow your 2007 Volkswagen New Beetle with a manual transmission I recommend the Demco #DM9518071. You don't need to worry about removing the arms when not towing and it's barely visible compared to some other kits.…

view full answer...

Answer 4

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 8

Hey Michael, The Falcon 5250 has direct-connect attachment points that hook onto a crossbar, if you remove the crossbar adapter then you'll be able to go with a direct-connect baseplate like the #RM77ZR (models with tow hooks) or #RM76RR (models…

view full answer...

Answer 9

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 10

Gladly! The difference between the Blue Ox Patriot 3 Radio Frequency, Portable Braking System BRK2019 and the Blue Ox Patriot Radio Frequency, Portable Braking System #BLU37TR is that the Blue Ox Patriot 3 RBRK2019 is older, no longer available, and…

view full answer...

Answer 11

2024 models of the Chevy Equinox have the same steps listed as the 2023 models to get the vehicle ready to flat tow: 1. Position the vehicle to be towed and secure it to the towing vehicle. 2. Start the vehicle. 3. If equipped with AWD, engage the…

view full answer...

Answer 12

Hello John. The #C96JR tail light kit for the 2023 Jeep Gladiator will indeed work with a Brake Buddy brake System Such as part #HM39524. So, if you plan to use a portable brake system, that is definitely what I recommend, and you do not need to get…

view full answer...